Result: Ladder

Hey Matthew! Thanks for the axle tag picture. Even though the capacity is 3,000 lbs it will still use the #84 spindle. The LCI35 is a 3,500 lb model designation so the Lippert Brake Drum and Hub Kit #LC72DX will work as a replacement. What kind of…

We sure do Jerry and welcome back! To replace the Replacement Dexter Versa-Flex Torsion Arm Kit item #DX24FT. This replacement arm is designed for a 3,700-lb Dexter Versa-Flex axle. It's going to replace the entire arm assembly and rotor hub. It…

Hey Jason! Yes, the etrailer Replacement Awning Fabric #e92AV can replace the fabric on your Solera powered awning. What you need to do is measure the distance from the center of the left arm to the center of the right arm. If that is 14' then…

Hey William, do you know what axle capacity you have on your Keystone Cougar? Or if you know the specific model of Half Ton that you have I can determine this as well. If it's the fifth wheel version of the Half Ton it should have a 4.4k capacity…

I was able to find out from Dometic, who took over Atwood's water heater division and the Replacement Control Panel #AT91367 you were looking at will be the correct part.

Hey, Brent! We have just what you need. I reached out to Lippert to get the information about the hub you need and you will bee Lippert part #LC72DX. This is a hub and drum assembly that is pre-greases so the seal, inner, and outer bearings are…

Hey Russ, I can't imagine you'd need a taller version of the Lippert On-The-Go than the 12-1/2 foot version part #LC64HD that we offer but you might take a tape measure out there with you and see if that would be tall enough. From what I…

We sure do Dan. The Furrion Microwave Trim Kit item #FR85TF is exactly what you need for the Furrion Built-In RV Convection Microwave and Air Fryer item #FR63TF in black. The Furrion Microwave Trim Kit item #FR85TF is black and measures 24-3/16"…

I sure can Scott! I verified with Roadmaster that their Direct-Connect Base Plate Kit item #RM23DQ does fit the 2026 Ford Ranger Raptor. It can indeed be flat towed and there are no other restrictions. This baseplate kit comes with all hardware…

I sure can Bob and thanks for the information! Since you have a Lippert 3,500 lbs axle you'll be able to use the Easy Grease Trailer Hub and Drum Assembly for 3.5K Axles item #AKHD-545-35-EZ-K, you were looking at. These have a 5 on 4-1/2 lug nut…

If your existing hubs have a 5 on 4-1/2 inch bolt pattern the Dexter Trailer Hub and Drum Assembly #84546UC3 will work perfectly. This hub uses the #L68149 inner bearing and #L44649 outer bearing, is designed for 3,500 pound axles, and the bearings,…

Hey Doug, congratulations on the new truck and trailer! That is a nice setup for sure. Unfortunately, the backup cameras aren't going to integrate with your dash cam system. Since you're already prepped for Furrion, and it is the best on the…