Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
Either will work for your 2013 Ford F-53 with a 22,000 GVWR. The Roadmaster Front Anti-Sway Bar, #RM-1139-148 fits the 18,000, 20,500, your 22,000 GVWR F-53 as well as the 24,000 and 26,000 GVWR chassis. The Roadmaster Front Anti-Sway Bar,…
view full answer...The Roadmaster #RM-1139-140 and #RM-1139-148 are both replacement anti-sway bars for a Ford F550 or F53 Class A motorhome chassis. Both bars are 1-3/4 inches in diameter. The #RM-1139-140 fits models with a GVWR of 22K-24K, and the #RM-1139-148 fits…
view full answer...Tire designations ST205/75D14 and ST205/75R14 are both for special trailer tires with a 205mm width, 75-percent aspect ratio and that fit a 14-inch wheel. The difference between them is the tire's type of construction. The ST205/75D14 tire is a…
view full answer...The best ST205/75R14 tire we have on offer will be the Westlake ST205/75R14 Radial Trailer Tire - Load Range D #274-000012. This is rated up to 2,040 pounds at 65 psi and has an L speed rating, or 75 miles per hour. It also has a 5-Year warranty that…
view full answer...For your 14 inch wheels, I recommend the Provider ST215/75R14 Radial Trailer Tire - Load Range D #TTWTRTM2157514D. This is a slightly smaller tire, but it is very well made. It is rated for 2,200 lbs at 65 psi and has a max speed rating of 81 mph. It…
view full answer...It is certainly possible for any axle to wear out enough over time to need replacing. Since the suspension is built into a torsion axle if the suspension part was to wear out pretty much the only solution would be to replace the axle. If the…
view full answer...You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…
view full answer...If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…
view full answer...The old version of the #HBA-CAM used 4 wires, but the product was updated awhile back and now uses only two wires as shown in the photo on the product description page. The white wire from the HBA-CAM would tap into the white ground wire and the blue…
view full answer...Thank you for purchasing from etrailer! You did a great job selecting compatible parts. When using Leaf Springs #e64SR with the #AP233 Equalizer Kit and the #H248 Hanger Kit, there should be 29-1/2" between the front and center hangers and…
view full answer...The 7290 that you see is a casting number. It is found on AL-KO hubs that fit #99 spindles. I found that the bearings used are #28580 which would be the inner bearing and #25580 which would be the outer bearing. For the seal use #91030.
view full answer...Unfortunately there are no plug-in adapters or harnesses that would allow you to replace the factory 4-way flat trailer connector with a 7-way or a 7-way and 4-way connector on your 2005 Ford F-150. To complete the installation for a brake controller…
view full answer...Filter Your Search
Contact and Help