Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…
view full answer...The Trailer Hub and Drum Assembly part #AKHD-545-35-K is the correct replacement for an AL-KO 7230. In regards to the braking assemblies, I suggest getting a new pair, the Electric Trailer Brake Kit part #AKEBRK-35-SA. This option will save you…
view full answer...There are many different wiring harnesses on Police Interceptors, and the photo you've attached is not a common fit for trailer wiring. I don't believe that harness is for your trailer wiring even though it looks similar. I've…
view full answer...Though we do have the replacement bearings, races, and seals available for your Hadco 3109 hub (which I have listed below), the combination used will not have an equivalent replacement hub available, unfortunately. Replacement Trailer Hub Bearing…
view full answer...You are definitely on the right track here. When it comes to weight distribution hitches, it all comes down to your tongue weight. All of these systems will have a range of tongue weights that you want to stay within for them to work effectively. I…
view full answer...For a weight distribution shank that has 2 more inches of drop than the part #RP54970 you'd want the part #RP63971.
view full answer...Weight Distribution is a good idea whenever the loaded weight of the trailer weighs more that 50 percent of the tow vehicles weight. In addition to eliminating the squat experienced when a trailer is connected, a weight distribution system has…
view full answer...The best way to pick out a weight distribution system is to base it off of the loaded tongue weight of the setup when it is loaded and ready to tow. This figure also includes the weight of any cargo behind the rear axle of the tow vehicle. I…
view full answer...Thanks for reaching out and providing photos! The head of your Reese Weight Distribution System part 113913 is designed to fit a shank with flush sides where the bolts secure like what we see with part part #RP54970, but the Replacement Hitch Ball…
view full answer...Yes, the cam of the Reese Dual Cam III part #RP65FR has been upgraded from models that were made 20 years ago. The brackets have also been upgraded and made to be a lot easier to install as well.
view full answer...The overall length of the Replacement Trunnion Spring Bar part #RP22225 from the end of the trunnion to the end of the bar is 33". I have attached a photo with this measurement for you as well. This spring bar is a direct replacement for…
view full answer...We don't carry TuffTow W/D kits, but a quick measurement of the width of the upright on your existing shank and the adjustment hole spacing will confirm if the Curt shank will work for you. As long as your current weight distribution hitch…
view full answer...Filter Your Search