Question

Question:

Do you just sell the bolts only, trying to connect a RM-4750 tow defender to a RM Nighthawk towbar, but that is yhe only part we are missing, we have everything else?

asked by: Kathleen M

0

Answer 1

Hello Kevin, Sorry for the delay, I had to reach out to Roadmaster on this one. Great question, I get what you’re saying about not wanting threads in the stack-up. Short answer, yes, the Replacement Car-Side Installation Hardware for Roadmaster Tow…

view full answer...

Answer 2

Hey Dave! The Ford Maverick AWD Hybrid is a really popular flat tow vehicle, so we've got everything you need on that flat tow but you'll always want to consult your owner's manual just for the extra surety that you're able to flat…

view full answer...

Answer 3

The difference between the #RM-4700 and the #RM-4750 is being able to use them with your base plates. If you have the crossbar on your base plates you will need part #RM-4700. The RM-4750 is not compatible with other style base plates. Since you said…

view full answer...

Answer 4

The difference between the #RM-4700 and the #RM-4750 is being able to use them with your base plates. If you have the crossbar on your base plates you will need part #RM-4700. The RM-4750 is not compatible with other style base plates.

view full answer...

Answer 5

The Roadmaster Tow Defender Protective Screening #RM-4750 is compatible with your Roadmaster Tow Bar and EZ5 Base Plates on the 2014 Fiat 500L. For the towed vehicle side connections, you will connect the support tubes by bringing the loose end of…

view full answer...

Answer 6

Hi Cheryl, With this style seal #DOM53FR you would need to remove the bowl from the stack in order to replace the seal. You'll start by removing the base shroud and then loosening the hose clamp and two off-white base clamps under the hose clamp.…

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

Both the Roadmaster and Blue Ox tow bars are great options. But if it was my decision to make I would go with the Blue Ox Avail part #BX7420 as we have found that the Blue Ox tow bars are a little easier to connect and disconnect from. Also this tow…

view full answer...

Answer 11

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 12

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Product Page this Question was Asked From

Continue Researching