Does A Dometic 200 Series RV Toilet Need To Be Taken Apart To Change The Seals
Updated 01/27/2026 | Published 08/23/2024 >
Question:
2004 Airstream w Dometic 200 series toilet. Do you have to take toilet apart to change seal? Or can it be changed through the flapper ball opening?
asked by: Cheryl
Expert Reply:
Hi Cheryl,
With this style seal # DOM53FR you would need to remove the bowl from the stack in order to replace the seal. You'll start by removing the base shroud and then loosening the hose clamp and two off-white base clamps under the hose clamp. I would loosen the hose clamp just enough to slip it off the base clamps and leave it still around the toilet.
Once separated you'll see the connection point between the stack and the bowl. The thinner blue seal will sit against the stack and the thicker black seal will sit against the toilet bowl. Both seals will sit against each other when in place and there's a small black plastic piece sticking up on the stack side that the notch in the seals will fit around.
There are other models that you can replace the seal without having to take the bowl off but this unfortunately isn't one. I've attached some pictures though to help walk you through the swap out.
Product Page this Question was Asked From
Replacement Toilet Bowl Seal Kit for Dometic 200 and 500 Series RV Toilets
- Accessories and Parts
- RV Toilets
- Seals and Gaskets
- Seal Kit
- Dometic
more information >
Continue Researching
- Video: Breaking Down the Flair-It PEX 90-Degree Elbow Fitting
- Search Results: window
- Search Results: dicor sealant
- Search Results: kwikee rv steps
- Search Results: pd4590k18ns2
- Shop: Replacement Toilet Bowl Seal Kit for Dometic 200 and 500 Series RV Toilets
- Shop: Replacement Toilet Bowl Seal Kit for Dometic Sealand and VacuFlush RV Toilets
- Shop: Vehicle Tow Bar Brake System
- Q&A: Replacement RV Toillet Bow Seal Kit for Dometic 506 Plus Toilet
- Q&A: Replacement Converter Section for PD4590K18NS2
- Shop: Flair-It PEX Female Adapter Fitting - Swivel - 1/2" FPT x 3/8" Barb
- Shop: Flair-It PEX Straight Coupler Fitting - 1/2" Barb x 1/2" Barb
- Shop: Flair-It PEX 90-Degree Elbow Fitting - Swivel - 1/2" FPT x 1/2" Barb
- Search Results: lp gas regulator
- Search Results: pex fittings
- Search Results: pex
- Shop: Replacement Steps, Motor, and Control for Kwikee RV Electric Steps - 25 Series - 24" Wide
- Shop: Blue Ox Patriot Portable Flat Tow Brake System - Proportional
- Video: An In-Depth Look at the Dometic 510 Full-Timer RV Toilet
- Video: Complete Breakdown of the Dometic 510 Full-Timer RV Toilet
- Video: An In-Depth Look at the Roadmaster Battery Charge Line Kit for Towed Vehicles
- Shop: Trailer Hitch
- Article: Trailer Wiring Diagrams
- Q&A: Does etrailer Carry Furrion Chill Cube w/ Heat Pump to Replace Dometic Duo-Therm
- Shop: Trailer Wiring
- Video: An In-Depth Look at the Roadmaster Diode 7-Wire to 6-Wire Flexo-Coil Wiring Kit
- Q&A: Best Suspension Upgrade for 33" Tandem Axles: Road Armor vs Dexter EZ Flex for Ember 22ETS
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Measure for Trailer Hitch Drop
- Shop: Suspension Enhancement








Katrina D.
1/27/2026
Hi Cheryl, how did the seal replacement on your Dometic 200 series toilet go after removing the bowl from the stack? Your update could make it easier for others working on the same model.