Looking For A-Frame Trailer Jack With 2" OD Tube
Updated 07/06/2026 | Published 07/02/2026 >
Products Featured in This Question
Question:
Hi, I am having a problem finding a replacement jack for my 2002 Jayco Eagle tent trailer. The smallest diameter I can find is 2 1/4 and my hole is only 2 inches. It is a top wind jack and I find picturs that look like the one I need but they all are 2 1/4 inches. I have purchased two jacks only to find they are too big to fit through the hoile in the tongue of the trailer. Also the ones we find extend to far below the tongue when fully retracted. Ours is only three inches below the tongue when attached and fully retracted. Even at this height we drag the jack on the ground in some places especially backing it into our driveway because of the slope. Is there anyting out there I can find that will fit my needs.
asked by: Clark F
Expert Reply:
Hey Clark, thanks for reaching out. The 2" OD A-frame jacks are pretty uncommon these days. Right now, we carry only one jack with a 2" OD tube, the A-Frame Trailer Jack # DL22530. The problem is, when this jack is fully retracted, the tube sticks down 8-1/4" below the frame. Based on the setup you are describing, this would not work for your trailer since it would sit too low and probably scrape the ground.
If I were you, I'd look at swapping out the A-frame jack for a side mounted jack like part # MJ-1200B. It comes with a bracket that bolts the jack to the side of the frame. Then the jack swings up out of the way when not in use, so you wouldn't have to worry about it scraping the ground. It'll fit any frame between 2" and 4" tall so as long as your trailers tongue meets that specification, this will be your best bet.
Product Page this Question was Asked From
etrailer Boat Trailer Jack w/ Wheel - Sidewind - Swivel - 11" Lift - 1,200 lbs
- Trailer Jack
- Boat Trailer
- Utility Trailer
- Side-Mount Jacks
- Swivel Jacks
- Sidewind Jack
- 1001 - 2000 lbs
- Manual Jack
- 11 Inch Lift
- Bolt-On
- With Wheel
- etrailer
more information >
Continue Researching
- Search Results: 11402
- Search Results: 98881
- Search Results: floor jack
- Shop: Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class V Commercial Duty - 2-1/2"
- Shop: NOCO Boost X Jump Starter - LED Work Light - 2 USB Ports - 12V - 4,250 Amp
- Shop: Mighty Cord Indoor/Outdoor Extension Cord w/ Indicator Lights - 15 Amps - 100' Long
- Shop: Pollak Heavy-Duty, 4-Pole, Round Pin Trailer Wiring Connector - Metal - Trailer End
- Shop: NOCO Genius Boost HD Jump Starter - LED Work Light - USB Port - 12V - 2,000 Amp
- Shop: Drop Leg for etrailer and Ram Jacks - 13-1/4" Tall - 5-1/4" Diameter Footplate - Zinc
- Shop: Trailer Hitch
- Search Results: mud flap
- Shop: Trailer Wiring
- Search Results: trailer hitch
- Article: Trailer Wiring Diagrams
- Video: Curt T-Connector Vehicle Wiring Harness Review C56040
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Search Results: trailer wiring
- Video: Firestone Ride-Rite Air Bags with Easy Mount Compressor Feature Breakdown
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Shop: Suspension Enhancement
- Article: How to Measure for Trailer Hitch Drop
- Search Results: trailer tires and wheels
- Video: The Low-Down on the Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector
- Video: Curt Mounting Bracket for 4-Pole Flat Trailer Connector Review
- Q&A: Recommended Bike Rack and Dual Hitch Adapter for Carrying E-Bikes While Flat Towing
- Shop: Brake Controller
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)



Lisa
7/3/2026
For a 5'2" 110 female who rides motorcycles, I have a 7x12 open trailer and a 7x18 aluminum enclosed trailer. This is a must for me and I couldn't be happier.