Looking For Electric Jack Replacement For 2010 Jayco Jayfeather 19H
Updated 06/25/2026 | Published 06/21/2026
Question:
Well i need a new trailer jack for my 2010 Jayfeather19h. Looking for info on electric. what i need and what is available to fit? Purchased one from fleet farm just to get the truck free so im not towing to get to work. But the height did not even get high enough to get the hitch off the ball without blocks. Im looking into it but thought maybe you would already know what specks i need. Any help would be really helpfull.
asked by: Blake w
Expert Reply:
Hey Blake, thanks for reaching out. We should definitely have an electric jack for you, but I don't have a way to look up your camper online to know exactly which one will fit. RV manufacturers just aren't that specific with their online literature.
Basically the big thing we'll need to nail down is the coupler height on your trailer, and the amount of lift you need.
A very popular option that works on most trailers is the Lippert Electric Trailer Jack # LC285318. It has 18" of total lift.
When fully retracted, the foot hangs down 10-3/4" below the trailer frame. Then fully extended, it drops down to 28-3/4". I edited a picture to help illustrate.
I suggest comparing these measurements to the trailer and the current jack setup and make sure this has enough range of movement to get the coupler up off the ball on your truck.
How much extension does the current jack have?
(click to enlarge)
Tom H.
6/23/2026
I have a 28 ft travel trailer and a f 150 Lariat, so she set better high and have no problem hooking up and removing it off my truck. I told etrailer what I had and I had no problem.My jack lifted 15 1/4 “ I hope this helps.
Jesse M.
6/23/2026
Drbill
6/23/2026
Blake, Sounds very familiar. On my previous trailer I replaced the hand crank jack with this one, and once, did not raise it up enough and bent it. Replaced it with same one and depending on terrain i sometimes have to use a 4x4 to get it high enough. When on a severe down slope, I cannot use a 4x4 as it will not let me level trailer from front to back when disconnected. In general I use a 4x4 but I have to check and not use it when the ground rises up as it is a real pain to remove the 4x4 after disconnecting but not impossible. My current trailer has this same one, so I know the drill.
Stan
6/24/2026
My new Lipert Electric jack works perfectly. It was easy to swap out, and has been flawless. I would purchase it again with zero concerns.
Jesse M.
6/24/2026
Bill S.
6/24/2026
I installed the lipert electric jack about a year ago on a 38 foot travel trailer and have a Ram 2500 with a 6 inch lift. The jack works great and was easy to install. I do put a 6x6 block under the jack but that is because I don't like having the jack extended to far out. But it does extend far enough without the block to get on and off the hitch.
Jesse M.
6/25/2026
Product Page this Question was Asked From
Lippert Electric Trailer Jack with Footplate - A-Frame - 18" Lift - 3,500 lbs - Black
- Camper Jacks
- Pop Up Camper
- Teardrop Camper
- Travel Trailer
- A-Frame Jacks
- Steel
- 3001 - 4000 lbs
- Electric Jack
- Bolt-On
- 1 Jack
- Lippert
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Furrion Variable Speed Chill Cube RV AC w/ Heat Pump & Ceiling Assembly - 18K Btu - Non-Ducted - R32
- Search Results: single ac rv ac soft start
- Search Results: rv air conditioners
- Video: Review of Furrion RV Air Conditioners - Black 18K BTU Variable Speed Chill Cube Ductless - FR87TQ
- Shop: Furrion Variable Speed Chill Cube RV AC w/ Heat Pump & Ceiling Assembly - 18K Btu - Non-Ducted - R32
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Video: Redarc Tow-Pro Liberty Brake Controller Review RED24FR
- Search Results: trailer hitch
- Shop: Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector
- Shop: Trailer Hitch
- Article: Trailer Wiring Diagrams
- Search Results: trailer jack
- Shop: Trailer Wiring
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Shop: Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Q&A: Does etrailer Carry Furrion Chill Cube w/ Heat Pump to Replace Dometic Duo-Therm
- Shop: Power Mountain Tallboy Off-Road Bottle Jack - 8-1/2" to 37-3/4" Lift - 6 Tons
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Availability of Heat Strip or Heat Pump for Furrion Chill Cube RV AC
- Search Results: trailer wiring
- Shop: Suspension Enhancement
- Article: 5 Things to Know About Weight Distribution Hitches
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Shop: etrailer Anti-Rattle Hitch Collar for 2" Hitch Receivers
- Shop: Brake Controller
- Video: Furrion Chill Cube RV Air Conditioner Review and Installation - Travel Trailer Edition
- Search Results: trailer tires and wheels
- Shop: Redarc Tow-Pro Liberty Brake Controller w/ Universal Wiring Harness - Dash Knob - Proportional
- Article: My Trailer Hitch Doesn't Fit
- Q&A: Best Suspension Upgrade for 33" Tandem Axles: Road Armor vs Dexter EZ Flex for Ember 22ETS
on Camper Jacks
Blake W.
6/22/2026
This is what i found on the internet for a Jayco 19h exp. Lift 3500 Total lift stroke -23" to 25" Screw travel 18" to 19.5 Drop leg 5" to 5.5" Retracted bracket -9 Extended height -28.5 Foot plate 5.5 Not sure what screw travel is? And is total lift -23 lowering after removed from truck? To 25" going up from truck?