Is There a Rebuild Kit for HappiJac Camper Jacks

Question

Question:

I have happijack 4500 and i need some parts. its a rebuilt kit These kits contain one of each gear along with a new short shaft and bushing with e-clip. thank you for reply

asked by: Simon C

0

Expert Reply:

Hey Simon, thanks for reaching out!

I spoke with my contact at Lippert (who owns HappiJac) and they said there aren't any rebuild kits available so you'll have to get a whole new jack as part # LC736514.

You can still look and see if someone has an outlying rebuild kit, but the odds are you're going to have to go this route instead.

How long have you been using the HappiJac system?

expert reply by: Jon G

0

Answer 1

Hey Michael, if you check out the attached picture you can see all of the individual components that come with the HappiJac Electric Truck Camper Jack System #LC736515-ELKIT that you referenced. Everything you'd need would come with this as it…

view full answer...

Answer 2

It looks like the HappiJac 4100 series jacks had 34.5" of travel, and there are some parts available to replace things in a pinch, but with newer trucks getting taller it might be wise to upgrade to a whole new set of jacks. I recommend taking a…

view full answer...

Answer 3

There are camper jacks that will allow you to take your camper off your truck bed easily, but there is nothing with wheels as that would not be stable enough so they do need to remain stationary. To choose the right camper jacks, you need to know the…

view full answer...

Answer 4

What jacks do you have installed on your 1999 Lance 845 truck camper? If it's an older model then the only solution I know of is to completely replace the jack system itself with part #LC736514-ELKIT for a 34-1/2" lift or part…

view full answer...

Answer 5

Congrats on the new camper! I have a solution but there unfortunately is not a manual to electric conversion kit for the HappiJac 4160 series jacks. The reason an electric conversion will not work for your 4160 is that they have a two piece…

view full answer...

Answer 6

I recommend using the Swing Out Extension Brackets for HappiJac Truck Camper Jack Systems item #LC182496 and the HappiJac Fixed Extender Bracket for Dual Wheel Chassis Truck Camper Jacks item #HJ54FR. The fixed extenders are only 5" wide apiece.…

view full answer...

Answer 7

If you're looking for just the L-bracket for your HappiJac Electric Truck Camper Jack System #LC736514-ELKIT then you'll need part #LC182492. The flat bracket can be swapped out with part #LC182494 and the swing brackets can be replaced with…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

Hey Jonathon thank you so much for all of that additional information! To haul your bikes behind your class C Sprinter motorhome, while flat towing your Mini, I recommend the Hollywood Racks RV Rider Bike Rack item #HLY64FR and the Roadmaster Dual…

view full answer...

Answer 12

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Is There a Rebuild Kit for HappiJac Camper Jacks

Product Page this Question was Asked From

Continue Researching