Will Yakima EXO Swing Away Storage System Work with 2024 Toyota Sienna Platinum  

Hello Boris, thanks for reaching out. In the case of the 2024 Toyota Sienna, all four of the hitches available are structurally, virtually identical. They all bolt on in the same location, they have similar side flanges, and the crosstube/receiver…

Yes, the Yakima EXO Swing Away Storage System w/ 2 Enclosed Cargo Carriers item #Y74ZR is compatible with the 2" receiver on your 2018 BMW X1. As far as exhaust heat goes, the shank on the swing away has a 2" rise to lift the carrier up and…

We've had customers with Class B RVs like your RoadTrek Zion leave reviews for how well the Yakima EXO Swing Away Storage System w/ 2 Enclosed Cargo Carriers #Y74ZR worked for them so I would feel confident letting you know how well it would work…

Hey Carole, thanks for reaching out! The Swagman Swivel Hitch Extender #S86SR has arms that are about 29-1/2" long. Swagman actually has a dimensional photo that gives more dimensions that you'll ever want that I'm attaching for you to…

The internal dimensions of the Yakima GearLocker Enclosed Cargo Carrier #Y44VR used for the Yakima EXO Swing Away Storage System #Y74ZR are 51-11/16" long x 17" wide x 14-5/8" tall. Those inside dimensions work for a good amount of…

Hello Crystal, thanks for reaching out. The Yakima EXO Swing Away Storage System w/ 2 Enclosed Cargo Carriers #Y74ZR will stick out 35-1/2". This is measured from the center of the hitch pin hole to the rearmost part of the rack. Can't say…

The total height from the bottom of the receiver tube to the top of the closed GearLocker on the Yakima Exo Swing Away Storage System #Y74ZR is 42-1/2 inches tall. I went ahead and attached a diagram that shows this height for your convenience.

Hey Boyd, For that Inno Quick Base #IN34MR when it talks about minimum and maximum crossbar spread being 23 5/8"-33-3/16" that is going to refer to the center to center measurement. Center of one cross bar to the other. As long as it is…

Most manufacturers simply state that using a hitch extender will reduce the tongue weigh of your hitch's capacity by 50%. There is a formula you can use because the standard ball mount about 11 inches, so you will determine the length difference…

A hi-low adapter like the part #RM-048-6 you mentioned is designed for a rolling load like a vehicle being flat towed behind a motorhome. Although it hasn't been designed for a hitch mounted accessory like a bike rack, it can be used for that…

What you read was true in most cases but you do not need an adapter. What you need is the Replacement Shank for Gen-Y Adjustable Ball Mount item #325-GH-304. This has four stacked 2" receivers that will allow you to mount your motorcycle carrier…

When we installed the Curt Receiver #C38JR we measured the inside height of the receiver at 12" where the Draw-Tite Receiver #DT79GR measured at 11-1/2". The Adapter #C26FV you found is only rated for use with tow bars as it was not…