2022 Ford F-350 Plug-In Wiring Harness for In-Bed Truck Camper
Updated 09/08/2025 | Published 06/01/2025 >
Products Featured in This Question
Question:
Does etrailer have a plug in wiring harness to connect a slide in truck camper to the truck ? My truck is a 2022 Ford f350 8 foot bed with a 7 pin connector in the rear bumper only. Would I need an additional connector in the left bed side ?
asked by: Tom B
Expert Reply:
Hey Tom, thanks for reaching out!
We can definitely get you up and running with the wiring on your camper - you'll just have to choose which option best suits you:
- Standard 7-Way Connector # C57010
- Magnetic 7-Way Wiring Kits # 319-S7-09 and # 319-S7-10
I prefer the magnetic setup just because it will still disconnect if you happen to forget to uncouple the wiring prior to pulling away from the camper. If you aren't concerned about it then feel free to go the standard 7-Way route!
Product Page this Question was Asked From
Curt 5th Wheel/Gooseneck Custom Wiring Harness w/ 7-Pole Connector for Aluminum Beds - 10' Long
- Custom Fit Vehicle Wiring
- 5th Wheel and Gooseneck Wiring
- Vehicle End Connector
- 7 Blade
- Plug and Lead
- Plug-In
- Hidden
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Trailer Wiring
- Shop: Suspension Enhancement
- Shop: EZ Connector Magnetic 5th Wheel/Gooseneck Custom Wiring Harness w/ 7-Way Connector - Watertight Seal
- Shop: Air Lift WirelessAIR Compressor System for Air Helper Springs - Bluetooth - EZ Mount
- Q&A: Best Way To Charge A Lithium Battery With A 7-Pin Trailer Plug On A 2021 Ram 2500
- Shop: Curt 5th Wheel/Gooseneck Custom Wiring Harness w/ 7-Pole Connector for Aluminum Beds - 10' Long
- Shop: Trailer Hitch
- Search Results: hopkins 41157
- Video: EZ Connector Custom Fit Vehicle Wiring - Fifth Wheel and Gooseneck Wiring - 319-S7-09 Review
- Shop: Air Lift LoadLifter 7500 XL Ultimate Air Helper Springs - Rear Axle
- Shop: Air Lift 1000 Air Helper Springs for Coil Springs - Rear
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Shop: Air Lift LoadLifter 5000 Ultimate Air Helper Springs with Internal Jounce Bumpers - Rear Axle
- Q&A: How to Install a 7-Way Inside the Bed of a 2019 Ford F-250
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Search Results: air bag compressor kit
- Search Results: on board air compressor
- Search Results: air spring
- Q&A: Should Spacer of Timbren Kit # TFRTT350J be Used Or Not Pros/Cons
- Search Results: air lift 25980ez
- Shop: Vehicle Sway Bars
- Shop: Floor Mats
- Shop: Tonneau Cover
- Video: Fit Test: WeatherTech All-Weather Rear Floor Mats with 2004 Toyota Avalon
- Video: DIY Installation for the Curt 5th Wheel/Gooseneck Wiring Harness - 2024 Ford F-350 Super Duty
- Video: An In-Depth Look at the B and W Hitch Receiver Reducer Sleeve
- Q&A: Benefits of Timbren Rear Suspension # TFR1525HD versus Sway Bar for 2006 GMC Sierra Extended Cab
- Video: Mount: B and W Companion Gooseneck-to-5th-Wheel Trailer Hitch Adapter on a 2022 GMC Sierra 2500
- Shop: Camper Tie-Downs
- Q&A: In-Bed 7-Way Trailer Wiring Socket Recommendation for a 2020 Ram 2500


Jon G.
9/8/2025
Hey Tom, did you decide to go with the magnetic setup for your camper wiring, or did you choose the standard 7-Way connector? I'm curious to know how it worked out for you, as it could help others in a similar situation.