Availability of Trailer Taillight Lens to Replace Wesbar DOT-SAE-AIST-99
Updated 05/19/2025 | Published 05/10/2025
Question:
Jameson....I also have a red 4 inch square Wesbar submersible tail light cover (that I cracked) that says: dot-sae-aist-99 on it. In looking at part number 2423286 on some sites it does not quite appear to be a "perfectly square" light cover like mine. Am I missing something? or over analyzing?
asked by: Al R
Expert Reply:
Hey Al, the correct replacement lens you'd need is the part # 440-15R as the part number you mentioned is actually not made anymore but the # 440-15R is exact same design. This lens is perfectly square though. The reason it might not look that way is because of the angle of the picture. How'd you crack your lens?
Product Page this Question was Asked From
Replacement Stop/Tail Red Lens for Peterson Incandescent Square Combination Tail Lights
- Accessories and Parts
- Trailer Lights
- Light Lenses
- 4-1/2 Inch Wide
- 4-1/2 Inch Long
- Square
- Red
- Peterson
more information >
Continue Researching
- Shop: Dexstar Vintage Steel Wheel w/ +5 mm Offset - 13" x 4-1/2" Rim - 4 on 9.44 - Silver
- Shop: Dexstar Vintage Steel Wheel w/ +5 mm Offset - 15" x 5" Rim - 4 on 9.44 - Silver
- Q&A: Replacement Trailer Taillight Lens for SAE Number sae-aist-99
- Q&A: Can E-Track be Installed in Car Hauler for Multiple Car Widths
- Q&A: Recommended Replacement For A UFP Model A-70 Brake Actuator
- Q&A: Compatiblity of STL9RGB and STL8RGB LED Lights with Trailer With Physical Ground Wire
- Q&A: After How Many Years Should Trailer Tires Be Replaced
- Q&A: Do Trailer Tires Have Average Life Span
- Article: Trailer Wiring Diagrams
- Q&A: Correct Replacement Lens For PM 440 151
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Trailer Lighting Requirements
- Article: Trailer Jacks
- Article: Best Landing Gear
- Article: How to Measure for Trailer Hitch Drop
- Article: Troubleshooting 4 and 5-Way Wiring Installations
Al R.
5/19/2025
Many thanks Jameson. This was very helpful for potential future reference/need. I lucked out and found a replacement lens from a buddy with an old (not used anymore) trailer. FYI......I cracked my lens by backing into a dock....hit the support (big....uh duh on my part....did not think I was that close).