What Size/Length Of Self-Tapping Screw For Mounting Marker Light Bracket?
Updated 09/26/2025 | Published 04/26/2025
Products Featured in This Question
Question:
What size length/width self-tapping screws do you recommend for use on a 1998 Tracker Trailstar? Does etrailer sell these too? Thx, sb
asked by: S B
1
Helpful Expert Reply:
Hello. So there is not a specific screw recommended based on a make and model of camper but if you are trying to mount a marker light bracket like part # A91BOB, a 1/4" - 14 x 3/4" long self tapping screw like part # FA1131822 would work just fine.
expert reply by:
Jesse M
1
Product Page this Question was Asked From
Mounting Bracket for Optronics A91, AL82, AL90, AL91, or AL191 Series Lights - Open Back - Black
- Accessories and Parts
- Trailer Lights
- Mounting Hardware
- Brackets
- Black
- Optronics
more information >
Continue Researching
- Q&A: Replacement Fender for Single Axle Escort Boat Trailer
- Q&A: Recommended Side Marker Lights for EZLoader Trailer
- Q&A: Availability Of White Replacement Fender For 2003 Shoreland'r Trailer W/ ST205/75R15 Tires
- Q&A: Recommended Replacement Converter for a Elixir ELX-45
- Q&A: Spacing Between Two Electric Connectors On Thinline LED Clearance and Side Marker Light AL91RB
- Q&A: Should Curt Tri-Ball Trailer Coupler Lock C48CR Rust After 6 Weeks
- Q&A: Replacement Tail Lights Recommendation for a 2005 EZ Loader Boat Trailer
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Trailer Lighting Requirements
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)
- Article: Trailer Tire Sizing
- Article: Trailer Wiring Diagrams
- Article: 7 Common Questions Everyone Has About Trailer Tires
Jesse M.
9/26/2025
Hey sb, did the 1/4 - 14 x 3/4 long self-tapping screws work for your Tracker Trailstar? I'm curious to know because it could help others looking to mount similar parts.