Can Existing Wires Be Used to Connect SeeLeveL RV Holding Tank Monitoring System
Updated 04/23/2025 | Published 04/22/2025 >
Question:
I have the three bolt sensors in my tanks, can I reuse those wires to tie the sensors in and then take those wire off the old display and wire into the new display?
asked by: Stanley R
Expert Reply:
Hello again Stanley; as long as you have 18 gauge wire for the signal wire and ground for each sensor that will work. However, if the trailer is older it is probably a good idea to run new wire to avoid any issues down the road while you're working on it. I went ahead and attached a picture of the wiring and wiring chart from the # SE99VR instructions below. The full instructions are linked a little further down on this page for your reference.
Product Page this Question was Asked From
SeeLeveL RV Holding Tank Monitoring System - Fresh, Gray, Black - Multiplex Compatible
- Smart RV
- Monitoring System
- Water Tanks
- Digital Display
- Monitors Only
- SeeLeveL
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Video: Installation: SeeLeveL RV Holding Tank Monitoring System on a 2022 Newmar Dutch Star Motorhome
- Video: Checking Out the SeeLeveL RV Holding Tank Monitoring System
- Shop: SeeLeveL RV Holding Tank Monitoring System - Fresh, Gray, Black - Water Pump Switch
- Search Results: heat pump
- Shop: Furrion Chill Cube RV AC System w/ Air Distribution Box & Remote - 18,000 Btu - Non-Ducted - R32
- Shop: Second Vehicle Breakaway Kit for Blue Ox Patriot Flat Tow Brake Systems
- Shop: Replacement Command Center Tablet for Curt RVibrake 3
- Shop: Vehicle Tow Bar Wiring
- Q&A: Does The Blue Ox Patriot Have An Internal Battery To Power The Unit During A Breakaway Event
- Video: Blue Ox Tow Bar Wiring Kit Installation - 2022 Chevrolet Colorado
- Video: The Low-Down on the Blue Ox 7-Wire to 6-Wire, Coiled Electrical Cord
- Search Results: coiled breakaway cable
- Search Results: blue ox flat tow wiring harness
- Search Results: brake systems flat tow brake system
- Search Results: trailer breakaway switch
- Search Results: blue ox tow bar
- Search Results: brake system
- Shop: Fastway Zip Trailer Breakaway Switch with Coiled Cable - 6' Long
- Shop: Blue Ox Acclaim Non-Binding Tow Bar - Coupler Style for 2" Ball - Car Mount - 5,000 lbs
- Shop: Blue Ox 7-Wire to 6-Wire, Coiled Electrical Cord
- Q&A: My Dometic Toilet Will Not Hold Water Is The Bowl What Do I Do?
- Article: Trailer Wiring Diagrams
- Video: An In-Depth Look at the Roadmaster Battery Charge Line Kit for Towed Vehicles
- Shop: Trailer Hitch
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Does etrailer Carry Furrion Chill Cube w/ Heat Pump to Replace Dometic Duo-Therm
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Video: An In-Depth Look at the Roadmaster Diode 7-Wire to 6-Wire Flexo-Coil Wiring Kit
- Shop: Trailer Wiring
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)





Stanley R.
4/23/2025
Thank you Robin, my concern is I will not be able to pull new wire through everything, I have a Thor ACE 30.1 class A. What are the can-hi and can-lo wires for and would you tie all the ground wires on the sensor together and then tie them to the ground on at the wire connector then tie all the blue wire signal wires together on the new sensor's together and tie them to the tank senders?