Installation Time for a Hitch on a 2009 Chevrolet HHR
Updated 01/04/2010 | Published 01/02/2010
Products Featured in This Question
Question:
Why does the Curt hitch #11447 require more install time than the HiddenHitch, DrawTite, and Valley hitches ?
asked by: tom
0
Expert Reply:
For this particular installation I do not see a difference in the installation so I believe the difference is just in the amount of time the manufacturers stated at the time of engineering. The installation is essentially the same for all of the hitches (see link) offered for the 2009 Chevrolet HHR. I would allow a bit more time, maybe 1-1/2 hours, for the installation if working off of the ground without a lift.
expert reply by:
Robert G
0
Product Page this Question was Asked From
Draw-Tite Sportframe Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Trailer Hitch
- For Towing
- Class I
- 200 lbs TW
- 2000 lbs GTW
- 1-1/4 Inch Hitch
- Visible Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Disc Brake Conversion Kit for a 5th Wheel Trailer w/ 7,000 lbs Axles
- Q&A: Recommended Replacement Slide-Out Seals For A 2012 Keystone Vantage QBS32 Travel Trailer
- Q&A: Replacement RV Slide Black Rubber Wiper Seal For 2016 Grand Design Reflection 313RLTS
- Q&A: Diagram with Dimensions for Curt Weight Distribution Shank C17132
- Q&A: What Are the Dimensions of the Everchill RV Refrigerator w/ Freezer Drawer- 17 Cu Ft
- Q&A: Does the Curt Helux Pin Box Work w/ a Anderson Ultimate 5th Wheel Hitch?
- Q&A: Redarc Tow-Pro Liberty Brake Controller Installation On a 2022 Chevrolet Blazer With Factory Towing