Can The Caliber Multi-Glides Be Cut Down To Size?
Updated 12/22/2025 | Published 10/15/2024
Question:
yes hello good morning. Can these Caliber Multi-Glides be cut down to size? What kind of saw to use? Thank
asked by: Hank
0
Expert Reply:
Hey there Hank, thanks for reaching out. The Caliber Multi-Glides # CA26TJ can indeed be cut down to size if needed. According to Caliber you can use any type of saw, but I would use a nice sharp hack saw and just cut them by hand.
expert reply by:
Jesse M
0
Product Page this Question was Asked From
Caliber MultiGlides for Snowmobile Trailers - 6-1/4" Wide x 60" Long - Qty 4
- Snowmobile Trailer Parts
- Traction Surface
- Glides
- 4 Pack
- 6-1/4 Inch Wide
- 60 Inch Long
- Caliber
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: 48 Feet of Replacement Slides for Snowmobile Trailer with Cracked Glides
- Q&A: Can Caliber EdgeGlide Be Used Between Ramp Door and Trailer Floor
- Q&A: Replacement Hubs for 4 Place Aluminum Newman Snowmobile Trailer With Dual Axles
- Q&A: Can Caliber Edge Glide 2.0 Transition Plate for Enclosed Trailers # CA42T Work on Plywood Ramp
- Q&A: Spare Tire Carrier Recommendation for Class C Motorhome
- Q&A: Should I Replace The ST145/R12 Trailer Tires Before Taking a 1,000 Mile Trip
- Q&A: Electric Trailer Brakes Lock Up Even with No Power Getting to Them
- Article: How to Charge a Trailer Battery While Driving: 3 Common Problems (And How to Fix Them)
- Article: Trailer Wiring Diagrams
- Article: How to Install E-Track in 3 Easy Steps
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: How to Change a Trailer Tire
Jesse M.
12/22/2025
Hey Hank, how did trimming the Caliber Multi-Glides go with the hack saw? Your results could really help others who need to shorten theirs too.