Replacement Gas Detector for 2014 Airstream

Question

Question:

I need to replace my LP Gas detector for my 2014 Airstream. It should be an Atwood/Dometic brand, model could be 31013. Can you help.

asked by: Jeff B

0

Expert Reply:

Hey Jeff, so we don't have the Atwood detectors anymore but the RV Safe part # RS44FR that you referenced would work great as a suitable replacement.

expert reply by: Jameson C

0

Jameson C.

1/5/2026

Hey Jeff, how did the RV Safe propane gas detector work out as a replacement for your old Atwood unit? Knowing how it performed could help others looking to update their Airstream detectors too.

Answer 1

The trim ring is not available, but the Atwood RV Carbon Monoxide and Propane Gas Detector #AT36681 can be mounted quite simply without it. I attached a page from the directions which shows how this is done; you simply remove the bezel from the…

view full answer...

Answer 2

The 2-Wire RV Propane Gas and Carbon Monoxide Detector #RS54FR is a flush mount design that has a cover plate with 7-1/4" length x 3-3/8" height x 1/4" thick with mounting holes that are center to center 6" apart so you should be…

view full answer...

Answer 3

The RV Propane Gas Detector part #RS64FR is what I recommend using to replace the the Atwood RV Propane Gas Detector part 31013 (Discontinued). The mounting plate for this new detector will cover up any holes you had for the previous so it will be a…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

You can use the RV Propane Gas Detector #RS64FR (white) or #RS44FR (black) to replace your current Atwood 31013 propane gas detector. This will also use a 12v, 2-wire installation like your current detector.

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

Both the Roadmaster and Blue Ox tow bars are great options. But if it was my decision to make I would go with the Blue Ox Avail part #BX7420 as we have found that the Blue Ox tow bars are a little easier to connect and disconnect from. Also this tow…

view full answer...

Answer 8

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 9

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Answer 10

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 11

Hi John; the RV Safe Propane Gas Detector is designed to replace old discontinued Atwood models. You can choose from the following based on color and if you want to add carbon monoxide detection. -RV Propane Gas Detector - 12 Volt - 2 Wire - White…

view full answer...

Answer 12

Hi Brenda, The Atwood 31013 unfortunately has been discontinued so you'd need to go with a completely new LP gas detector. We have a couple of surface mount style detectors that come with trim rings that will cover the old unit's cutout hole…

view full answer...

Replacement Gas Detector for 2014 Airstream

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching