Replacement Valterra RV Sewer Termination Adapter
Updated 01/19/2026 | Published 08/07/2024
Question:
I need to replace the Termination Adapter 3 Slip Hub on my trailer. 2 of the tabs were broken off as a result of a tire blow out. The problem is if I cut off the old one it only leaves me with about 3/8 to glue the new one on and I dont feel this is adequate. Any ideas on how I should proceed? Thank you. Paul
asked by: Paul B
0
Expert Reply:
You are correct that 3/8" won't be enough. If you can't use a heat gun to loosen your broken termination adapter like item # T1029-2 off then you'll need to replace what's behind it.
expert reply by:
Jerred H
0
Product Page this Question was Asked From
Valterra RV Sewer Termination Adapter - 3" Lug Fitting to 3" Hub
- RV Sewer Hose Fittings
- Sewer Adapters
- Termination Adapters
- Hub
- Lug
- Sewer Hose to Sewer Outlet
- 3 Inch Diameter
- 3 Inch Diameter
- Valterra
more information >
Continue Researching
- Q&A: What To Do When The Bayonet Lugs Break Off Of The Sewer Fitting
- Q&A: Replacement Seal for Valterra Valve Fitting Adapter
- Q&A: Replacing Bayonet Fitting On 3 Black RV Sewer Pipe
- Q&A: Will Replacement Seal for Valterra 3 inch Caps T201 Fit Flush King
- Q&A: Replacement Seal for Flush King Reverse Flush Valve
- Shop: Valterra Waste Valve for RV Black Water Tank - Twist On - 3" Bayonet Hooks to 3" Lug
- Shop: Replacement Seal for Valterra 3" Caps and Hose Adapters
- Shop: Valterra Hydroflush Reverse Flush Adapter for RV Holding Tanks and Sewer Hoses - 45-Degree
- Q&A: Surge Protector for 2026 Thor Pasadena 34XG With 50A Service
- Q&A: Are the Valterra Waste Valves Directional as Far as Direction of Flow?
- Article: Converting Your RV Water Heater to Tankless
- Article: 5 Reasons to Convert Your RV Lights to LEDs Today
- Article: Trailer Tire Sizing
- Article: Trailer Wiring Diagrams
- Article: How to Install an RV Awning From Scratch
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Article: The Ultimate RV Camping Checklist for Your First Year RVing
Jerred H.
1/19/2026
Hey Paul, were you able to get the broken termination adapter off your trailer using a heat gun, or did you end up replacing the section behind it? Knowing what worked could help others facing the same repair.