Replacement Tire for 1990 Calkins 1719-2450 Trailer
Updated 02/17/2026 | Published 06/21/2024
Products Featured in This Question
Question:
I have a 1990 Calkins 1719-2450 that I bought new in 1990. I recently had a tire blow out and it appears the other side is compromised. Looking more closely at the situation I notice tire rub marks on the inside of the fender wells. The tires on it were ST215-75r14. Tires have been replaced over the years. What size tire should I be running. The traier title shows a GVRW of 2993lbs. Thanks Dana
asked by: Dana
Expert Reply:
Hey Dana, it would be in your best interest to go with a slightly narrower tire size than what you have with the 205/75-14 like the part # AM10235. This will do a great job on your trailer and also would prevent the rubbing. I would assume this is the size your trailer had on it prior.
Product Page this Question was Asked From
Replacement Trailer Hub Bearing - L44649
- Trailer Bearings Races Seals Caps
- Bearings
- Standard Bearings
- 1.06 Inch I.D.
- Bearing L44649
- Race L44610
- 3500 lbs Axle
- etrailer
more information >
Continue Researching
- Article: Most Popular Wheel Bearings
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Q&A: What Is The Smallest Available Spindle Nut For 2.5k Axle?
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Hydraulic Trailer Brakes: How They Work & What to Buy
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: Trailer Wiring Diagrams
- Q&A: How to Determine Replacement Trailer Wheel Bearing Sizes
- Q&A: Replacement Grease Seals For TRP GS-1719DL
- Q&A: Does Ventline E-Z Lift Ventadome Trailer Roof Vent # V3092-603-00 Have Ceiling Garnish
- Q&A: What Is the Difference Between a BTR and BT8 Spindle
- Q&A: What is a #84 Spindle and How Do I Know I Have One On My Trailer?
- Article: How to Tell the Weight Rating of a Trailer Axle
- Q&A: How to Identify Replacement Leaf Springs
Jameson C.
2/17/2026
Hey Dana, how did the 205/75-14 tires work out on your Calkins trailer? It’d be great to hear if switching to the narrower size stopped the rubbing inside the fender wells. Your update could make it easier for others with the same trailer setup.