Does Equal-i-zer Weight Distribution Pin Replacement Work with Fastway WD

Question

Question:

Will these pins work with the Fastway E2?

asked by: M. R

0

Expert Reply:

Yes, the Equal-i-zer pins part # EQ95-01-9430 that you referenced do work with Fastway weight distribution systems.

expert reply by: Jameson C

0

Jameson C.

2/17/2026

Hey, did the Equal-i-zer pins end up fitting your Fastway E2 setup the way you needed? Knowing how they worked could help others using the same system.

Answer 1

The L-pins on the Fastway e2 systems are a little different than those used with the Equal-I-zer system but #EQ95-01-9430 can be used. For the e2 system we also have replacement L-Pin #FA92-03-9205. The clip is #FA92-04-9208. Each of these are sold…

view full answer...

Answer 2

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 3

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 4

Hey Jon; I was actually just talking to Furrion about heat options for the Chill Cube yesterday (1/21/2025). At this time, the only way to have heat with this unit is through a furnace on a ducted setup. The Furrion Chill Cube RV AC w/ Air…

view full answer...

Answer 5

Hey Brian! Yes, the Firestone Ride-Rite Air Helper Springs #F89VV will fit your 2025 Toyota Tundra. That is just the generic picture attached to that page, I can see how it would be confusing. These are designed to mount over the axle, and are…

view full answer...

Answer 6

It sure can Larry. The Mach-C Everest Variable Speed RV Air Conditioner System item #CM35MR includes an air distribution box that can be used for a top down set up. There's a baffle built into the air distribution box that can be removed to push…

view full answer...

Answer 7

While I was unable to confirm the exact dimensions of the Norcold 1200LRIM, I think your current refrigerator to be 63-1/4 inches tall, 32-11/16 inches wide, and 24 inches deep. Please confirm this. The Everchill RV refrigerator with freezer drawer…

view full answer...

Answer 8

Hey Robert, thanks for reaching out. If you're going from a Dometic 511 to a Dometic 411, you'll need to check which floor flange is currently installed. The 411 uses a standard 2-bolt RV toilet flange, while some older 511 installations used…

view full answer...

Answer 9

Hey Garret, I would definitely go with what Equal-I-zer recommended with the part #EQ37120ET which would be the correct rated system for your 2019 Heritage Glen 282RK. You are correct in that if you go with a system that is rated too high you will…

view full answer...

Answer 10

Hi David; the Timbren Rear Suspension Enhancement System #TDR1500DS is not available with a lower capacity. All of the Timbren SES bump stops come with a high capacity like these. If 1,500 lbs is enough the SumoSprings Solo Custom Helper Springs…

view full answer...

Answer 11

I edited a picture to show measurements for this Replacement L-Pins #EQ95-01-9430. This pin will work with Equal-i-zer weight distribution systems rated for 6,000 lbs - 14,000 lbs GTW. I hope this helps.

view full answer...

Does Equal-i-zer Weight Distribution Pin Replacement Work with Fastway WD

Product Page this Question was Asked From

Continue Researching