How Long is the Square Direct Weld Jack TJD-15000SP-F w/ out the Leg?

Question

Question:

Item TJD-15000SP-F What is the body length? excluding the leg portion.

asked by: Jason

0

Expert Reply:

I checked with Ram and without the leg the Square Direct Weld Jack item # TJD-15000SP-F is right at 22" long.

expert reply by: Jerred H

0

Answer 1

The rule of thumb for estimating a tongue weight is 10-15 percent of trailer weight. So your 14,000 pound trailer would have a tongue weight between 1400 lbs and 2100 lbs so any trailer jack rated over 2,500 lbs would be sufficient to lift the…

view full answer...

Answer 2

Since you are limiting your trailer to 10000lbs, and the average tongue weight is 10-15% of the trailer weight, you are looking at 1000-1500lbs tongue weight. With that said it is a good idea to use a jack with a larger capacity as it will be able to…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

Send me the pictures you have and I'll see if it's something we can get.

view full answer...

Answer 6

Hi Jon, It sounds like you're looking for replacement jacks for a landing gear system for a trailer. The etrailer Dual-Pin Two-Speed Jack w/ 20,000lb Static capacity part #e45YV can be used in a landing gear system as it has the fitting a cross…

view full answer...

Answer 7

This updated design etrailer Dual-Pin Two-Speed Square Tube Jack - 20,000 lb Static / 12,000 lb Lift #e45YV allows you to keep the crank handle on the upgraded 2 speed side and just switch between gearing ratios by pulling or pushing in. It still has…

view full answer...

Answer 8

Hi Wade, Yes, you’ve definitely got some good options to get away from hand cranking, and I totally get wanting something easier, especially with a cattle trailer. A lot of cattle trailers are gooseneck style and use a square center-mounted jack like…

view full answer...

Answer 9

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 10

Hi Mike! We do have the Replacement Rod and Nut for Ram Square, Direct Weld Jacks - 12K #TJD-12000-RODNUT for your jack (I looked it up on Big Tex's website and it is a 12k Ram jack), but that is the only replacement part currently available. If…

view full answer...

Answer 11

Hey Bryant. The total lift measurement does include the drop leg. The Square Direct Weld Jack item #e42ZV you were looking at has a 28-3/4" total lift range that is measured by the 15" of screw travel, which is the actual jack itself, and…

view full answer...

How Long is the Square Direct Weld Jack TJD-15000SP-F w/ out the Leg?

Product Page this Question was Asked From

Continue Researching