LED Replacement Light for Command 003-6020 on 2009 Jayco

Question

Question:

Can I use this as a replacement for a Command 003-6020 light on my Jayco 2009 tent trailer?

asked by: Thien C

0

Command Light on Jayco
(click to enlarge)

Expert Reply:

Hey Thien, thanks for the picture of the Command light you have on your Jayco. Yes the part # 328-003-6019R that you referenced would work great in place of it.

expert reply by: Jameson C

0

Answer 1

Thanks for reaching out, Doran! The toggle switch for your FIC-ETJ3500 is pretty unique and it looks like for a direct replacement you'll need to reach out to FIC Jack Services directly at 1-877-957-1501. You might consider looking at and…

view full answer...

Answer 2

The Redarc instructions for the Plug-and-Play Wiring Harness #RED39FR you purchased only lists through 2019 because they haven't updated the instructions as of yet, but the adapter will fit your 2023 Nissan Frontier and allow you to install the…

view full answer...

Answer 3

From your axle tag I can tell you have a 5,200 lb trailer axle that has 86.5 inches from hub face to hub face, 68.5 inches from spring seat center to spring seat center and comes with hubs that have a 6 on 5-1/2 inch bolt pattern. While we have axles…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 8

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 9

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 10

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 11

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 12

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

LED Replacement Light for Command 003-6020 on 2009 Jayco

Product Page this Question was Asked From

Continue Researching