Recommended Replacement Landing Gear Legs and Rebuild Kit for a 2007 Dutchmen Northshore
Updated 05/15/2024 | Published 05/12/2024
Products Featured in This Question
Question:
I have a 2007 DutchmenNorthshore 28lbs with wheel and my drivers side lead landing gear doesnt not raise up unless constant pressure is applied to the leg then it will go up about half way pulled the cap off the leg and the gears are loose would I need a whole leg or can I just replace the gears attached is the tag on the inside of the cap
asked by: Brad S
(click to enlarge)
Expert Reply:
Thanks for the picture, Brad. If the leg is in good shape otherwise, I'd recommend just going with a rebuild kit opposed to a whole leg.
You can use the Lead Jack Repair Kit for Stromberg Carlson Landing Gear # LG-146059 for the lead legs and # LG-146060 for the follow leg.
If you decide that you do want to replace the entire leg, then you'd need the Replacement Lead Leg for Venture 5th Wheel RV Landing Gear # LC119102 for the lead leg or the Replacement Follow Leg for Venture 5th Wheel RV Landing Gear # LC119101 for the follow leg.
Product Page this Question was Asked From
Replacement Follow Jack w/ Drop Leg for Stromberg Carlson Landing Gear - 29-1/2"
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Legs
- Follow Leg
- Stromberg Carlson
more information >
Continue Researching
- Search Results: vmc900l
- Search Results: venture landing gear
- Search Results: toy hauler door lock
- Search Results: trailer suspension parts
- Search Results: 5th wheel suspension
- Search Results: thetford toilet parts
- Search Results: happijac bed
- Shop: Landing Gear Set w/ Handle - 36-1/2" Lift - 8,000 lbs
- Shop: Replacement Follow Leg for Venture 5th Wheel RV Landing Gear
- Video: Complete Breakdown of the Replacement Lead Leg for Venture 5th Wheel RV Landing Gear
- Shop: Replacement Lead Leg for Venture 5th Wheel RV Landing Gear
- Shop: Revive RV Cabinet Kit - 75' Roll - Blonde Walnut
- Shop: Cam-Action Lockable Door Latch w/ 36" Pipe for Enclosed Trailers - Zinc Plated Steel
- Q&A: Replacement Jack Legs for Venture VMC900R Landing Gear
- Q&A: What Can Damage The Internal Gears Of My 5th Wheel Jack?
- Q&A: Weight Capacity of Landing Gear Lead Leg 119102
- Q&A: Replacement Lead Leg for VMC900L with Stripped Thread/Nut
- Q&A: Can a Single Motor Venture Landing Gear Set be Converted to a Dual Motor System
- Q&A: Troubleshooting 5th Wheel Landing Gear That Retracts But Wont Extend
- Q&A: Replacement Landing Gear Legs for Venture Landing Gear
- Shop: Lippert Electric Landing Gear Set - 37" Lift - 6,000 lbs
- Shop: Stromberg Carlson Manual Landing Gear Set - Weld On - 34-7/8" Lift - 8,000 lbs
- Video: Stromberg Carlson Replacement Landing Gear Leg Installation - 2017 Starcraft Solstice Fifth Wheel
Brad
5/14/2024
If I replaced the leg how can I tell for sure if it's a weld on or non weld on leg