Weight Capacity of Landing Gear Lead Leg 119102

Question

Question:

What is the weight capacity of this leg. Can I get a replacement screw nut for this leg?

asked by: Dan

0

Expert Reply:

The Replacement Lead Leg for Venture 5th Wheel RV Landing Gear # LC119102 is rated for 3,000 lbs and when paired with the follow leg 6,000 lbs combined. We don't carry the inner nut and screw replacement for this landing gear leg so if that is damaged you will need to replace the entire leg.

expert reply by: Jason S

0

Answer 1

Thanks for the picture, Brad. If the leg is in good shape otherwise, I'd recommend just going with a rebuild kit opposed to a whole leg. You can use the Lead Jack Repair Kit for Stromberg Carlson Landing Gear #LG-146059 for the lead legs and…

view full answer...

Answer 2

It could be some internal parts but it could also be the electrical system itself. The easiest way to know if the internal parts are the issue or not is to use the manual override to see if it will extend and retract without any electricity. If it…

view full answer...

Answer 3

Though I could not find anything about the T46059 repair kit you referenced, but odds are the jack isn't rated high enough for the weight of your trailer. Or there is more than just the gears that need to be replaced. What you will probably want…

view full answer...

Answer 4

Based on what your VMC900L has wrong with it the best option would be to replace the lead leg with part #LC119102.

view full answer...

Answer 5

The Venture VMC900R is a very common landing gear set so for replacement legs we know you need the part #LC119102 for the lead leg and #LC119101 for the follow leg. Since you are wanting to fix the issue as cost effective as possible I would…

view full answer...

Answer 6

To make the single motor landing gear into a dual-powered landing gear you will need to replace the existing follower leg with a lead leg #LC119102, add a new gear box LC276602, motor #LC142178, and switch #LC145236. It would be easier and cost less…

view full answer...

Answer 7

Thanks for the pictures. You won't need to replace the entire landing gear set. For your Venture landing gear on your 2002 Forest River Cedar Creek Fifth Wheel you will want item #LC119102 for the lead leg or item #LC119101 for the follow leg.…

view full answer...

Answer 8

What you described does sound like a damaged gear box. This is pretty common for Venture landing gears like what you said you have and the correct solution is a new gear box which the part #LC276602 is the correct replacement for. For a replacement…

view full answer...

Answer 9

I have a few different options for you depending on the route you would like to take. However, regardless of which route you pursue you will need to take some measurements of your outer jack tube length and weld stop spacing. If you are handy and the…

view full answer...

Answer 10

The Enclosed Trailer Ramp Spring #ERS120D81 that you referenced is an excellent option to help you lift the ramp on your 2006 Gearbox Toy Hauler. It has a 120-lb weight capacity so if your door weighs over 120 lbs, say 150 lbs for example, then you…

view full answer...

Answer 11

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 12

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Weight Capacity of Landing Gear Lead Leg 119102

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching