Weight And Length Of the Saris MHS Bike Rack for 1 Bike

Question

Question:

Saris MHS Bike Rack for 1 Bike. What is the weight of this item. What is the overall length of it. Thanks

asked by: Tom

0

Expert Reply:

Hi Tom,

The Saris MHS Bike Rack for 1 Bike # SAR23MR weighs approximately 67lbs and has an 80lb bike capacity. The overall length from the hitch pin hole to the furthest point on the rack is approximately 27". If you need any other info just let me know and I'd be happy to help.

expert reply by: Kevin C

0

Theresa

2/23/2024

There are two different weights listed, with the difference of 30 pounds. Can you tell me which is correct for this model? Thank you.

Kevin C.

3/5/2024

@Theresa As a single-bike carrier the Saris MHS Bike Rack for 1 Bike # SAR23MR has an 80lb capacity. When using the add-on # SAR78MR the first wheel tray (closest to the vehicle) would still be 80lbs and the add-on tray would be 35lbs. If you get the two bike version # SAR73MR then the first two trays would be 80lbs and the add-on # SAR78MR would be 35lbs. The amount of trays you can have is going to vary by base, with the # SAR23MR the base can only accept one extra add-on tray for a total of two bikes.

Answer 1

Red lithium grease such as #L11390 is one we use often here for installations and it is compatible with other Lithium formulas. I have included a link to our help article that covers grease compatibility. There are greases that are not compatible…

view full answer...

Answer 2

The speed rating of your ST205/75R15 tire will be stamped in the sidewall, and not all tires have the same rating. For example we offer the Karrier ST205/75R15 Radial Trailer Tire - Load Range C #AM10244 which has an 81 MPH speed rating where a…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 7

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 8

Hi Ken! It looks like you have almost everything you need to set up your 2026 Jeep Gladiator Sahara for flat towing. The etrailer Invisible Base Plate Kit - Removable Arms #e98948 is a perfect fit and the etrailer XHD Non-Binding Tow Bar - RV Mount -…

view full answer...

Answer 9

Hey Rick! Yes, the EcoHitch Hidden Front Mount Trailer Hitch #EH57FR will fit your 2024 Silverado 2500. The only other options is the Curt #C52NR. I'm not sure what capacity you're looking for, but this is half of the EcoHitch at 500 lbs. The…

view full answer...

Answer 10

Hey Charles, the Swagman E-Spec part #S45SR is rated for use at the rear of a travel trailer so it will work great for you. It is odd that it's not closer connected to the other RV rated bike racks but that's our fault and I'll see if I…

view full answer...

Answer 11

Hey Scott. The Lets Go Aero Jack-E Bike Rack item #LGA92ZR does not swivel and doesn't have a simple process for swapping out propane tanks. You'll need to remove the bolts attaching the tray to the supports to be able to remove your propane…

view full answer...

Answer 12

Hey Angi, welcome back! You will most likely need to use the Swagman Bike Frame Adapter Bar item #S57FR for a step thru framed bike. The hooks on the Swagman E-Spec Pro Bike Rack item #S45SR don't go down far enough to secure bikes with real low…

view full answer...

Weight And Length Of the Saris MHS Bike Rack for 1 Bike

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching