Does The Dragon's Eye LED Clearance or Side Marker Light # DG52440VP Provide 180 Degree View?

Question

Question:

on the Dragons eye LED side marker/clearance light...........does this have a 180 degree view?

asked by: MEC

0

Expert Reply:

The Dragon's Eye LED Clearance or Side Marker Light # DG52440VP goes beyond a 180 degree view. As you can see on the image below you can see the amber color projecting back onto the trailer surface it is mounted on.

expert reply by: Bud M

0

Dragon's Eye LED Clearance or Side Marker Light # DG52440VP On Trailer
(click to enlarge)

Answer 1

Hey Scott, the Optronics Smoke Lens ID Light Bar #OPT95KB that you referenced is weather proof but not waterproof or intended to be submerged so it does not have an IP rating. Instead we have the part #OPT88FR which is submersible though. It…

view full answer...

Answer 2

Hi Gordon, Yes, you can use the Dragon's Eye LED Clearance or Side Marker Light - Amber Lens #DG52505VP or Red Lens #DG52438VP on your cargo trailer to replace your incandescent lights.

view full answer...

Answer 3

The term PC-Rated in reference to trailer lighting means Photometrically Certified. What this means in actual practice is that a light fixture is viewable from a 90-degree angle. Other non-PC-rated lights are considered to be viewable from a 45…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 9

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 10

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 11

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 12

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Does The Dragon's Eye LED Clearance or Side Marker Light # DG52440VP Provide 180 Degree View?

Product Page this Question was Asked From

Continue Researching