Will Telesteps Ladder Standoff and Tool Tray # TE89FR Fit on Lippert On-The-Go Telescopic Ladder?

Question

Question:

Will this work on the lippert telescoping ladder?

asked by: Gary G

1

Helpful Expert Reply:

The Telesteps Ladder Standoff and Tool Tray # TE89FR is specifically designed to fit on Telesteps ladders like # TE44FR which have the oval vertical uprights. The uprights on the Lippert On-The-Go Telescopic Ladder # LC64HD are round and will not allow for the

expert reply by: Bud M

1

Answer 1

Hey Bernard, thanks for reaching out! The Lippert On-The-Go Telescopic Ladder #LC64HD does have the mounting brackets 2 rungs below the top of the ladder, but I do see the case you're making about wanting to lower the brackets even more to make…

view full answer...

Answer 2

I recommend using foam tubular pipe insulation on the top rung of your Lippert On-The-Go Angled Telescopic Ladder, #LC64HD if you are concerned with possible damage/scratches to your motorhome. The rung is 1-1/2" so you will want to purchase…

view full answer...

Answer 3

I spoke with Lippert about the mounting brackets for the Lippert On-The-Go Telescopic Ladder #LC64HD and found out that they are only sold as an OEM part. This means that only the motorhome/trailer manufacturer is able to order them so you…

view full answer...

Answer 4

Joe, I was able to track down a diagram and find out that the Telesteps Telescopic A-Frame Ladder #TE37FR is 15.4" wide all the way up and down until it reaches the base where it extends to 30.1".

view full answer...

Answer 5

Hey Dennis, The bracket the mounts to the trailer wall would need to be installed at the factory and unfortunately isn't an option aftermarket. These are relatively new so I'm assuming after enough people complain to Lippert they'll start…

view full answer...

Answer 6

The MaxxFan Deluxe Roof Vent w/ 12V Fan #MA00-07500K that you referenced is designed to fit the standard 14 inch by 14 inch RV roof vent openings which you most likely have in your Keystone. Since I believe you have a Ventline VD0434 currently this…

view full answer...

Answer 7

The base of the Telesteps Telescopic A-Frame Ladder #TE37FR has a 49" spread from outside edge to outside edge.

view full answer...

Answer 8

With the verticle bar broken you will likely need a complete ladder to make it safe again. It sounds like you could use a Surco #SP502L Universal Exterior Ladder to replace your broken one. This ladder measures 84-1/2" tall and will work on many…

view full answer...

Answer 9

The Telesteps Telescopic Ladder #TE64FR weighs only 24lbs. The small shape makes it much easier to maneuver when carrying it long distances and it is also much easier in windy conditions since you do not have the large framework like a traditional…

view full answer...

Answer 10

Yes, you're needing the SnapPad BF 10 Jack Pads for Quadra BigFoot Leveling System w/ 10" Octagon Jack Feet #SN26FR. These pads are a simple one-time installation. Simply place the pads under the jack feet of your levelers and extend them…

view full answer...

Will Telesteps Ladder Standoff and Tool Tray # TE89FR Fit on Lippert On-The-Go Telescopic Ladder?

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching