Replacement Zip Straps for Yakima Ridgeback Bike Rack

Question

Question:

I have the Yakima Ridgeback 2 with BLACK release buttons. Which zip strips do I need? Thx

asked by: Ken

1

Helpful Expert Reply:

The replacement zip straps part # Y55XR are correct for your Yakima Ridgeback bike rack.

expert reply by: Jameson C

1

Answer 1

If you look at the provided diagram, you can see the replacement parts that Yakima offers for your Ridgeback Bike Rack. If what you're needing isn't shown, please let me know what you're needing. Zip strips #Y8890297 Endcap #8890306…

view full answer...

Answer 2

Since you have a Yakima Ridgeback bike rack part #Y02458 the correct zip strap replacements is the part #Y8890297.

view full answer...

Answer 3

I checked with Yakima and the newer Replacement ZipStrip Straps for Yakima SuperCush Bike Rack Cradles #Y55XR are not compatible with the pre-2015 Yakima Ridgeback bike rack. For those years you will need the Replacement ZipStrip Straps for Yakima…

view full answer...

Answer 4

Cradles can wear out, and you can replace them for your Yakima RidgeBack 4-Bike Rack #Y02458. The cradles come with the ZipStrips, so if you just need those, I'll list the part numbers for them, as well as the cradles if you want to replace them…

view full answer...

Answer 5

Hello Bob, thanks for reaching out. The Replacement ZipStrips #Y8890297 you were looking at will fit the Yakima FullSwing, RidgeBack and SwingDaddy bike racks. I am not quite sure what you mean by "sidewinder cradle for tandem", but as long…

view full answer...

Answer 6

Yes, I confirmed with Yakima that the zip straps part #Y55XR is the correct strap for the Yakima BackRoad.

view full answer...

Answer 7

We do carry the replacement zip straps you are looking for with the part #Y55XR.

view full answer...

Answer 8

Yakima Tube Top Bike Adapter Bar #Y02531 will fit loosely on the bike until the bike is placed on a hanging style bike rack. At that point gravity pulling the bike down, and the bike rack arms holding the adapter bar up, will keep it secure. So it…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 12

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Replacement Zip Straps for Yakima Ridgeback Bike Rack

Product Page this Question was Asked From

Continue Researching