Where do Red and White Wires Go On Progressive Dynamics Converter Replace # PD4645V

Question

Question:

i bought a replacement power comverter with battery charger for a Magnetex series 6300A model 6345. With the wiring where does the I believe number 6 red and white wires go on the new board?

asked by: Michael T

1

Helpful Expert Reply:

The red wire should go to the terminal labelled +VCC and the white should go to the terminal labelled NEG- on the DC panel of the part # PD4645V.

I attached a link to the install instructions for this on this page for you to check out as well.

expert reply by: Jameson C

1

Answer 1

Thanks for the pictures! The Replacement Converter for your Magnetek Converter Series 6300 Model 6332 is going to be the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers - 35 Amp item #PD4635V.

view full answer...

Answer 2

The Replacement Section #PD4635V is the correct replacement converter for your Parallax 6336.

view full answer...

Answer 3

Hey Dave, so you bought the #PD4645V converter section for your magnatek 6345 converter, is that correct? If so, the #PD4645V does have a jumper which can be set to the Li or Lithium mode. I have included a screenshot of the instructions below to…

view full answer...

Answer 4

Hey Steven, what you have now is not compatible with an AGM battery. This is because AGM batteries require a special charging profile. So what you would need to do is upgrade the lower section of the converter with the part #PD4645V which has an AGM…

view full answer...

Answer 5

Thanks for the picture! I checked with Progressive Dynamics the replacement power converter you need for your Parallax Series 7300 Model 7345 is the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers - 45 Amp item #PD4645V.

view full answer...

Answer 6

The Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers #PD4635V is 35 amp. This is going to be slightly more than the 32 amp you are currently getting from your Magnetek 6332. But it is not going to charge your batteries noticeably…

view full answer...

Answer 7

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 8

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 9

If you are just looking for a new converter, the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers part #PD4635V will be a direct upgrade for the Magnetek Converter Series 6300 Model 6332 that you have now.

view full answer...

Answer 10

Hey Kyle! That is correct. The Coleman-Mach Mach-C Everest has variable-speed cooling and an inverter-driven compressor. However, the Mach-C Everest uses a traditional wall thermostat instead of a remote control. It also works with both ducted and…

view full answer...

Answer 11

Yes, you do have the exact right replacement converter for your 45 amp Magnetek 6345, which is the option from Progressive Dynamics: - Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers - 45 Amp #PD4645V I have added links below to…

view full answer...

Answer 12

Hey Ken, welcome back! So this is a really great question but at the end of the day the Curt A25 part #C16046 and the B and W Companion part #BWRVK3600 that both fit the OEM pucks of your 2026 Ram 3500 are really nice hitches that you can't go…

view full answer...

Where do Red and White Wires Go On Progressive Dynamics Converter Replace # PD4645V

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching