Replacement Ratchet Winches For a Demco Kar Kaddy X Tow Dolly

Question

Question:

Will this fit a DEMCO Kar Kaddy X?

asked by: Leon K

0

Expert Reply:

Yes, the Replacement Right Side Ratchet Winch for Demco Kar Kaddy # DM5433 will fit the Demco Kar Kaddy X Tow Dolly # DM9713093. I was able to verify this using the owners manual.

The correct left side winch replacement is the Replacement Left Side Ratchet Winch for Demco Kar Kaddy # DM5432.

expert reply by: Scott S

0

Answer 1

Hey Pete, The #DM5432 and #DM5433 will fit any Demco Kar Kaddy 3 tow dolly. If your 2012 tow dolly is a Kar Kaddy 3 these will be a direct replacement for you. What model is your 2012 dolly?

view full answer...

Answer 2

It looks like you have a Roadmaster tow dolly. If that's the case, the ratchet itself is part #RM-2110 and the ratchet mounting bracket is the part #RM-2000-31 that you'd looked at. The bracket and ratchet will fit either the driver or…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

Hey Melissa, thanks for reaching out. It doesn't look like Demco provides an online version of the instruction sheet for replacing the #DR74FR fender, but I can give you some general instructions. First, you'll want to remove the damaged…

view full answer...

Answer 7

They come in separate parts as opposed to a single kit, but we do indeed have brakes for your Demco Kar Kaddy SS tow dolly, with the following parts: - Replacement 10" Brake Rotor #DM03927-92 - Replacement Brake Caliper Assembly #DM13825-92 -…

view full answer...

Answer 8

Thanks for the pictures! We do have a different style ratchet option for your older tow dolly but you will need to measure the size of the bracket on your current ratchet. The most likely option we have is the Replacement Left Side Ratchet Winch…

view full answer...

Answer 9

Great question, Mark! I reached out to my contact at Demco and he said that each dolly is shipped with a decal that gives the model number, date of manufacture, VIN Number, Weight Capacity, etc. The decal location can vary depending on the tow dolly…

view full answer...

Answer 10

Hey Doug, I checked with Brophy and the Brophy Camper Jacks #CX74 have a distance of 3 inches from the upright mast to backside of the bracket that would hold your camper shell. We do not have a version of this without the feet.

view full answer...

Answer 11

Yes, the Replacement Left Side Ratchet Winch #DM5432 that you referenced is also the correct replacement part for your Demco Kar Kaddy SS model Tow Dolly. If you need the right side assembly as well you will use part #DM5433.

view full answer...

Answer 12

I spoke with my contact at Demco and they offer three different sizes for the replacement wheel straps for their Kar Kaddy. For standard you would want the #DM03528, for small #DM03528-81 and for large #DM03528-93. It sounds like you are looking for…

view full answer...

Replacement Ratchet Winches For a Demco Kar Kaddy X Tow Dolly

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching