Availability of Aluminum Wheel and Tire Size ST185/80R13

Question

Question:

Looking for a ST185/80R 13 tire, mounted on a Aluminum wheel, 5 bolt....available ? thanks

asked by: Jeff M

0

Expert Reply:

We have a bias ply tire in the size of ST185/80R13 mounted on a 5 lug aluminum wheel with the part # AM3S339 which is really close to what you mentioned. Otherwise you'd need to have an aluminum wheel like the part # AM22323HWT mounted to a radial tire in the size you want like with the # AM10208.

expert reply by: Jameson C

0

Answer 1

Hey Ron, if you order a wheel and tire from us like the part #AM3S339 that you referenced it will come with the correct rated valve stem to allow you to run it up to the max tire pressure that the tire is rated for without any issue. If the tire…

view full answer...

Answer 2

Hey Jon, none of our trailer wheel and tire combos are balanced as trailer wheels don't generally get balanced. With that said we do have balance beads with the part #CA66VR if you wanted to balance them yourself easily. Have you noticed wheel…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 5

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 6

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 7

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6 inch whereas the 225/75-15 fits widths that are 5 inch to 6-1/2 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Answer 8

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 9

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 10

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 11

Hey Clarence. There's no way to look at a tire or wheel and tell if it's a 5 on 4-1/2 or a 5 on 5 but you can take a real quick measurement to figure it out. If you'll look at the picture below you'll see a wheel with a red line on…

view full answer...

Answer 12

Hello Jason, thanks for reaching out. Yes, the Kenda Karrier KR53 ST205/75R15 tire with 15" black aluminum wheel #KE58JV does come balanced from the factory. Trailer tire and wheel assemblies are balanced by matching the tire’s high and low…

view full answer...

Availability of Aluminum Wheel and Tire Size ST185/80R13

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching