How Does Optronics Cam-On Mounting Bracket Work and What Trailer Lights Fit It

Question

Question:

Could you do a video on this product? Does this use the same light as you would put in a grommet? Thank you

asked by: Andy

0

Expert Reply:

I made a video for you showing how Optronics trailer light bracket # BK5557GB works with a light. This bracket will accept the following lights:

LED applications: MCL-55, MCL-56, MCL-57, MCL-527, MCL-51, MCL-58, MCL-59
Incandescent applications: MC-55, MC-57

And you would use a wiring pigtail, # A46PB, which will just plug into the back of the light.

expert reply by: Michael H

0

Answer 1

For a 2-3/4" cutout hole we currently only have two options, the Optronics #A56GB (closed back) and #A57GB (open back). These grommets are compatible with lights like the Optronics #MCL57RB or #OPT94FR. You'll need a 2-pin wire harness…

view full answer...

Answer 2

For the Optronics Clear LED Round Utility Light, part #UCL55CB, the grommet and brackets are different than those you listed. I will list the correct items you need for this light. The grommet needed for this light is part #A54GB. The mounting…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 7

Hey Jairo. So we do not offer a direct replacement for the Norcold N611, but we do have a good replacement option for you. It really comes down to what will fit in your cutout space. Take a look at the Norcold RV Refrigerator w/ Freezer - 8.2 cu ft -…

view full answer...

Answer 8

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 9

Hey Kelvin, welcome back. To flat tow a 2026 Ford Maverick with your Demco Commander II Tow Bar item #DM9511012, I recommend the following parts: Baseplate Kit - Demco Tabless Base Plate Kit item #DM38CV Wiring Harness - Roadmaster Diode 7-Wire to…

view full answer...

Answer 10

Stuart, since you’ve already confirmed the truck and trailer wiring through the junction box and verified the grounds, the fact that the running lights, brake lights, backup lights, and turn signals all work individually points us toward the tail…

view full answer...

How Does Optronics Cam-On Mounting Bracket Work and What Trailer Lights Fit It

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching