Replacement Pitch Arm Assembly for a Lippert Edge Awning on a 2022 Forest River Cherokee Alpha

Question

Question:

I am trying to locate a part for a solera awning. Short bar that is used to adjust the pitch with the thumb screw. Part was damaged from water sitting on top of the awning.

asked by: Jeremy C

0

Expert Reply:

The small pitch arm is not offered separately for the Lippert Edge awning you have, so you'd have to replace the entire assembly with the Replacement Drive Arm Assembly for Lippert Edge RV Awnings with LEDs # LC22ED and the Replacement Idler Arm Assembly for Lippert Edge RV Awnings with LEDs # LC62ED.

expert reply by: Bryce D

0

Answer 1

Since you said you have the 58 inch arms that would indicate that you have the Lippert Edge awning which we have just the replacement arms for. For the idler arm you'd want the part #LC62ED and for the driver arm part #LC22ED.

view full answer...

Answer 2

Thank you for providing your part number Steve. I was able to verify you will need the Replacement Idler Arm Assembly #LC75AF. We also have the Replacement Drive Arm Assembly #LC85AF.

view full answer...

Answer 3

Hi Jesus, The number you provided comes back as a Solera Edge awning in black, but we'll need a bit more information to determine the correct arm because there's 3 different models in black. There should be another sticker on the arm with a…

view full answer...

Answer 4

Hello Gary, thanks for providing all of the info and part numbers for your awning. That does come back as one of the Lippert 2000 series awnings. It sounds like you might be looking for the Replacement Pitch Arm Assembly #LC93BX which is for the 2000…

view full answer...

Answer 5

In order to determine the correct replacement for your Lippert Edge awning you'll need to measure the length of your wall mount (see attached photo). Once you've got that number you can look for a replacement based off of that measurement.…

view full answer...

Answer 6

For your 58 inch Lippert Edge RV awning the correct replacement idler arm is the part #LC62ED and the correct replacement drive arm (one with the motor) is the part #LC22ED.

view full answer...

Answer 7

Since your Solera arm is 58 inches long that would indicate it's a Solera Edge awning which means for a replacement drive arm you would want the part #LC22ED or for a replacement idler arm part #LC62ED.

view full answer...

Answer 8

We do have the Black version as part #LC62ED.

view full answer...

Answer 9

When it comes to replacing the power awning arm on your Lippert Edge Awning model The Solera Smart Arm 12V Power RV Awning Conversion Kit - Programmable - 63 inch Arms - Black #LC759516 is what you will need. We do not sell then individually you…

view full answer...

Answer 10

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 11

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 12

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Replacement Pitch Arm Assembly for a Lippert Edge Awning on a 2022 Forest River Cherokee Alpha

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching