Availability of 60" Tall Guide-On Posts For Boat Trailer With 3" x 5" Frame

Question

Question:

do you have a 60" high guide on that will attach to my frame which its 3" wide and 5" high?

asked by: Julian H

0

Expert Reply:

We have exactly what you're looking for. You can use the CE Smith Post-Style Guide-Ons for Boat Trailers # CE27646 (black) or # CE27640 (white). Since your frame is 5" tall you will also need the Extra-Long U-Bolt Kit # CE11416.

expert reply by: Robin H

0

Answer 1

The best way to determine the height needed is to measure from the top of your trailer frame to the top of the sides of your boat. If the 40" Tall Guide-Ons #CE27626 sit right at or slightly above the sides of your boat then the shorter will…

view full answer...

Answer 2

Thanks for the photos, nice boat! I think with a boat of that size, you would be better off getting the large post-style guides as the smaller ones may not be sufficient and would be harder to see. I would go with the CE Smith Post-Style Guide-Ons…

view full answer...

Answer 3

The CE Smith Roller-Style Guide-Ons for Boat Trailers #CE27610 measure 17-1/2 inches horizontally. It mounts on 3 inch frames and roughly 3 inches of it is a portion which cannot be adjusted to so you will have approximately 11-1/2 inches that you…

view full answer...

Answer 4

Though we do not have an option that would have a perfect 90 degree angle, I may still have something that would work. The CE Smith #CE27610 is a little smaller and typically installed on the outside of a trailer frame, but can be used however…

view full answer...

Answer 5

Hello Dan, Great question, and to be honest I was not sure of the answer, so I reached out to my friend Carol at CE Smith. This was Carol's response about the holes on the CE Smith Roller-Style Guide-Ons for Boat Trailers - 15" Tall - 1 Pair…

view full answer...

Answer 6

Hey Steve, you can trim down the Tie Down Modular Marine Glide Ons for Boat Trailer Bunks like part #TD69FR so what I would do is use the curved end piece for the transition section onto the bunks like you mentioned and then trim down the opposite…

view full answer...

Answer 7

Sounds like you are referring to guide on rollers like the CE Smith Roller-Style Guide-Ons for Boat Trailers #CE27610. These mount at the rear of the trailer frame and act as a guide to allow the boat to slide on as easy as possible. I attached a…

view full answer...

Answer 8

Hey Chris, thanks for reaching out, and nice boat! Based on what you are describing, I'd go with the bunk-style guide-ons. Since you usually aren't power loading, the bunks will help catch the hull and keep it centered. Plus, the bunks help…

view full answer...

Answer 9

The CE Smith Keel Roller for Boat Trailers - Self Centering #CE29505 is a replacement roller for a keel roller assembly. This self-centering roller fits a 12" wide bracket with a 5/8" shaft. In order to use this on your boat trailer you…

view full answer...

Availability of 60" Tall Guide-On Posts For Boat Trailer With 3" x 5" Frame

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching