Will the DeeMaxx Disc Brake Caliper item # DE86VR Work on a Nitro Bass Boat Trailer?

Question

Question:

Will it fit on 2021 nitro z20 bass boat

asked by: John B

0

Expert Reply:

The DeeMaxx Disc Brake Caliper item # DE86VR is not going to fit on 2021 Nitro Z20 bass boat but so long as you have a mounting bracket for disc brakes it will fit on your trailer. These are pretty universal.

expert reply by: Jerred H

0

Answer 1

Hi Jack, The 33" or 35" spacing is measured from the center of one axle to the center of the other axle (measurement C in diagram). If this isn't a new build and your just replacing suspension components then I'd recommend measuring…

view full answer...

Answer 2

Yes, axle spread and wheel base by definition are the same measurements. You will measure from the center of one axle to the center of the 2nd axle to determine what you axle spread is. This may be difficult as some wheels and covers will make this…

view full answer...

Answer 3

I believe we can narrow this down based on the information you are referencing. However, the best way to be sure is to measure your existing bearings or spindle with a digital caliper like the #PTW80157. It looks like one bearing is stamped with…

view full answer...

Answer 4

Finding information on the Tie Down 46250 was not an easy task as it was discontinued awhile back. From what I could find, it looks like the calipers marked 46250 often times have to change the mounting bracket and rotor/hub in addition to the…

view full answer...

Answer 5

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 6

Hello Rob, thanks for reaching out. The Kodiak Disc Brake Caliper #KDBC225DAC is exactly what we recommend for replacing the Tie Down 46304 calipers. We have confirmed on multiple occasions that the Kodiak caliper is a suitable replacement For the…

view full answer...

Answer 7

Hello again, Rob. Those Easy Grease Trailer Idler Hubs #AKIHUB-545-35-EZ-K you ordered use a lithium complex multipurpose grease. This is compatible with a variety of other greases, but what I recommend is the Red LubriMatic LMX Industrial Strength…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 12

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Will the DeeMaxx Disc Brake Caliper item # DE86VR Work on a Nitro Bass Boat Trailer?

Product Page this Question was Asked From

Continue Researching