Replacement Shroud for Dometic Brisk Air II RV AC Unit

Question

Question:

We have a 2016 Jayco Jay Feather X19H with a Dometic AC Model 3314851.000. The rooftop shroud needs to be replaced, but I cannot figure out how to find the correct replacement. The shroud measures approx. 27-5/8 x 29-5/8 x 12. Could you please let me know what I need to buy. Thank you.

asked by: Linda F

0

Expert Reply:

Based on the numbers you listed you have a Dometic Brisk Air II which means the correct replacement shroud is the part # DMC46FR.

expert reply by: Jameson C

0

Answer 1

Hey Bill, thanks for reaching out! All you need to do is swap your black cover over to the Replacement RV Air Conditioner Cover for Dometic Brisk Air II #DMC46FR you were looking at in order to help fight the Arizona sun damage. I confirmed this with…

view full answer...

Answer 2

I can confirm using the model number of your old unit (57915.751) that you have a Dometic Brisk Air III RV Air Conditioner and the correct replacement shroud for this is the Replacement Shroud for Dometic Brisk Air II RV Air Conditioner part…

view full answer...

Answer 3

Based on the SKU number you mentioned what you have is a Dometic Brisk Air II which the part #DMC46FR is the correct replacement shroud for.

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

You can use the RV Propane Gas Detector #RS64FR (white) or #RS44FR (black) to replace your current Atwood 31013 propane gas detector. This will also use a 12v, 2-wire installation like your current detector.

view full answer...

Answer 7

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 8

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 9

Hey Jon; I was actually just talking to Furrion about heat options for the Chill Cube yesterday (1/21/2025). At this time, the only way to have heat with this unit is through a furnace on a ducted setup. The Furrion Chill Cube RV AC w/ Air…

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 12

Congrats on the new motorhome Edward! SnapPad doesn't have the 2026 Allego Red 38 KA in their system so I don't know what size your jack feet are. However, we have a few options that will work with the HWH leveling systems. What you'll…

view full answer...

Replacement Shroud for Dometic Brisk Air II RV AC Unit

Product Page this Question was Asked From

Continue Researching