Replacement Shroud for Dometic Brisk Air II AC Unit

Question

Question:

I have a Dometic Roof top AC unit that i need a replacement cover. I bought the travel trailer new in 2014 and the Dometic tag shows a SKU# of 9105304464 What cover do i need?

asked by: John T

1

Helpful Expert Reply:

Based on the SKU number you mentioned what you have is a Dometic Brisk Air II which the part # DMC46FR is the correct replacement shroud for.

expert reply by: Jameson C

1

Answer 1

Hey Rick, There's typically only shroud either in black or white for an air conditioner so there isn't really a better option available. Is your shroud getting dried out from the Sun and cracking? If so you can try to prolong the lifespan of…

view full answer...

Answer 2

Hi Craig! The Replacement Shroud for Dometic Brisk RV Air Conditioner - Polar White #DMC27BQ is not the correct replacement shroud for you Brisk II air conditioner. Instead, you should use Replacement RV Air Conditioner Cover for Dometic Brisk Air II…

view full answer...

Answer 3

Based on the numbers you listed you have a Dometic Brisk Air II which means the correct replacement shroud is the part #DMC46FR.

view full answer...

Answer 4

Hey Bill, thanks for reaching out! All you need to do is swap your black cover over to the Replacement RV Air Conditioner Cover for Dometic Brisk Air II #DMC46FR you were looking at in order to help fight the Arizona sun damage. I confirmed this with…

view full answer...

Answer 5

I can confirm using the model number of your old unit (57915.751) that you have a Dometic Brisk Air III RV Air Conditioner and the correct replacement shroud for this is the Replacement Shroud for Dometic Brisk Air II RV Air Conditioner part…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

You can use the RV Propane Gas Detector #RS64FR (white) or #RS44FR (black) to replace your current Atwood 31013 propane gas detector. This will also use a 12v, 2-wire installation like your current detector.

view full answer...

Answer 11

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 12

Hey Jon; I was actually just talking to Furrion about heat options for the Chill Cube yesterday (1/21/2025). At this time, the only way to have heat with this unit is through a furnace on a ducted setup. The Furrion Chill Cube RV AC w/ Air…

view full answer...

Replacement Shroud for Dometic Brisk Air II AC Unit

Product Page this Question was Asked From

Continue Researching