Correct Replacement RV Air Conditioner Shroud for Coachmen Catalina

Question

Question:

I have a 2010 Coachmen Catalina 17RD. Im in need of a air-conditioning top cover due to mine cracking and broken pieces in some area. Thank you for support.

asked by: Marvin B

0

Expert Reply:

I can confirm using the model number of your old unit (57915.751) that you have a Dometic Brisk Air III RV Air Conditioner and the correct replacement shroud for this is the Replacement Shroud for Dometic Brisk Air II RV Air Conditioner part # DMC46FR.

expert reply by: Conner L

0

Answer 1

Based on the SKU number you mentioned what you have is a Dometic Brisk Air II which the part #DMC46FR is the correct replacement shroud for.

view full answer...

Answer 2

Hey Bill, thanks for reaching out! All you need to do is swap your black cover over to the Replacement RV Air Conditioner Cover for Dometic Brisk Air II #DMC46FR you were looking at in order to help fight the Arizona sun damage. I confirmed this with…

view full answer...

Answer 3

Based on the numbers you listed you have a Dometic Brisk Air II which means the correct replacement shroud is the part #DMC46FR.

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 9

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 10

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 11

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 12

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Correct Replacement RV Air Conditioner Shroud for Coachmen Catalina

Product Page this Question was Asked From

Continue Researching