Recommended Center Cap for a 15 Inch Aluminum Liger Trailer Wheel

Question

Question:

I hit a pothole with my LionsHead Liger R15 Rim and lost the plug on the center cap. Do you carry those? How much? Thanks

asked by: Michael S

0

Expert Reply:

We have two center caps that will work with a Lionshead Liger 15" rims. I have listed them below:

Lionshead Trailer Wheel Center Cap w/ Snap-In Plug - 4.25" Pilot - Stainless Steel item # LHCS108-SI60C

Replacement Center Cap for 15" or 16" Aluminum Viking Series Wheels - Gloss Black item # CXF104B

expert reply by: Jerred H

0

Answer 1

Thanks for the purchase, and you have a pair of options that will fit the Aluminum Liger Trailer Wheel - 15" x 6" Rim - 6 on 5-1/2 - Black #LH49FR: - Lionshead Trailer Wheel Center Cap w/ Snap-In Plug - 4.25" Pilot - Stainless Steel…

view full answer...

Answer 2

The Aluminum Liger Trailer Wheel #LH39FR has a 4.88" pilot diameter. This means the correct cap is the Lionshead Trailer Wheel Center Cap #LHCS109-SI60C.

view full answer...

Answer 3

Based on the information and images I could find on your 2020 Grand Design 2500RL you will need the Grease Cap #DC200L-DCRP. This fits an inner hub diameter of 1.99" which is most common on your 3,500lb axles. For the center cap I recommend the…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 6

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 7

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 8

Hey Melanie. The reason you can't find a replacement for your GE ARC15AACBL2 15,000 btu air conditioner is because they phased them out. In 2025 all RV AC systems had to change over to a new coolant called R32. This was a EPA mandated decision.…

view full answer...

Answer 9

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Answer 10

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 11

Hey Tim welcome back! Your ARH15AACBL2 GE AC unit has the old 410a refrigerant in it so the GE Appliances item #GE64FR you were looking at isn't going to work as a replacement. The EPA mandated R32 refrigerant has been used in all new AC's…

view full answer...

Answer 12

The closest side marker light we have for those dimensions is the LED Trailer Clearance or Side Marker Light with Reflex Reflector item #328-K-51. This oval light measures 4" and has mounting holes that are 3" center to center.

view full answer...

Recommended Center Cap for a 15 Inch Aluminum Liger Trailer Wheel

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching