What's the Spacing Between Mounting Tabs on the Front Jacks of the Lippert 5th Wheel Leveling System
Published 04/19/2023
Question:
How far apart are the mounting tabs on the front landing gear? I have a 2021 Cherokee Wolf Pack 335Pack13 5th Wheel Toy Hauler. My tabs are roughly 17 1/2inch to the outside and 15 1/2inch to the inside. Just want to make sure these will work when I take off the original landing gear. Thanks.
asked by: Jeff V
Expert Reply:
The mounting tabs on the front jacks of the Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System # LC358590 have the same measurements as your current landing gear. 15-1/2" between the tabs and 17-1/2" from the top of the top tab to the bottom of the bottom tab. This is a pretty standard spacing that most companies in the industry use.
Product Page this Question was Asked From
Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad - 4-Point Set
- Camper Jacks
- 5th Wheel Camper
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Electric Jack
- 36 Inch Lift
- Bolt-On
- 4 Jacks
- Lippert
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Bluetooth Control - 6-Point Set
- Shop: Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad - 4-Point Set
- Search Results: lippert camper jacks
- Video: Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System Installation - 2020 Forest River Ch
- Video: How to Install the Lippert Ground Control 5th Wheel RV Leveling System - 2015 Forest River Vengeance
- Search Results: 50 amp breaker
- Search Results: 50 amp fuse
- Shop: Circuit Breaker - 50 Amp - Perpendicular Mount Bracket - Cycling Auto Reset - Plastic - Type I
- Shop: Derale Automatic Resetting Circuit Breaker - 50 Amp
- Q&A: How Much Room on RV Frame Does Lippert Ground Control Middle and Rear Jacks Take Up
- Q&A: Clearance Required Around Rear Jacks of Lippert Ground Control 3.0
- Q&A: Installation Of The Lippert Ground Control 3.0 Jack Leg Mounting Brackets
- Q&A: Mounting Plate Height of Replacement I-Beam Jack Bracket for Lippert Ground Control
- Q&A: How to Determine if Lippert Ground Control 3.0 Will Fit 5th Wheel RV
- Q&A: Can Rear Jacks of Lippert Ground Control be 24 inches From Rear Axle
- Q&A: 6 Point Automatic Leveling System Recommendation 2010 Keystone Montana Fifth Wheel
- Shop: Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector
- Article: Trailer Wiring Diagrams
- Shop: Trailer Hitch
- Video: A Look at the Power Mountain Tallboy 6 Ton Off-Road Bottle Jack with a Military Cargo Trailer
- Search Results: trailer hitch
- Shop: Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Search Results: trailer jack
- Shop: Trailer Wiring
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Search Results: trailer tires and wheels
- Shop: etrailer Anti-Rattle Hitch Collar for 2" Hitch Receivers
- Video: How to Choose a Trailer Brake Controller
- Shop: Suspension Enhancement
- Article: How to Measure for Trailer Hitch Drop
