Is It Normal For A Trailer Hitch Receiver Tube To Slope Down
Published 03/16/2023 >
Question:
It appears that hitch receivers on two of my vehicles have a slop to them from front to rear. It is especially obvious when I use a hitch extension. Is this a feature and all hitches supposed to be not levelled, or is this failing hitch receiver, or a badly done factory installation?
asked by: Sergey
Helpful Expert Reply:
The receiver tube isn't always completely level due to manufacturer issues and with how it could sit when bolted to the frame of the vehicle. Having been around a lot of hitches I can tell you with certainty that the majority of hitches either have a very slightly off centered weld or get a bend to them during transportation, we even made a help article about how to straighten them out which I've attached below.
Based on the picture you provided and you stating that you're seeing it slope down more when using a hitch extension you aren't experiencing any manufacturer or installer defects. Using a hitch extension places more of the tongue weight solely on the receiver tube instead of evenly distributing it across the crosstube of the hitch and into the frame of the vehicle, causing the sag. This is why we always say that a hitch extender reduces your hitch's capacity by 50%.
The only way to prevent the sag is to load less on hitch extension to not overload the receiver tube of the hitch.
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: Karrier ST205/75R14 KR53 Radial Trailer Tire - Load Range D
- Shop: Karrier KR35 ST205/75R14 Radial Trailer Tire - Load Range D
- Shop: Trailer Hitch
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Q&A: How Do I Get a Slightly Bent Hitch Straightened Out So It Can Be Installed on 2019 Ram 1500 Classic
- Q&A: Does Tow Hook of 2007 Honda Fit Interfere with Install of Trailer Hitch
- Search Results: trailer hitch
- Article: Trailer Wiring Diagrams
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Shop: Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector
- Shop: Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Shop: Trailer Wiring
- Search Results: trailer tires and wheels
- Q&A: Comparing Kenda KR03, KR35, And KR53 Tires
- Shop: etrailer Anti-Rattle Hitch Collar for 2" Hitch Receivers
- Shop: Suspension Enhancement
- Search Results: trailer wiring
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Video: Curt T-Connector Vehicle Wiring Harness Review C56040
- Shop: Brake Controller
- Search Results: trailer jack
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Which is Better for Highway Use 4.80-12 or 5.30-12 Trailer TIres
- Shop: Power Mountain Tallboy Off-Road Bottle Jack - 8-1/2" to 37-3/4" Lift - 6 Tons
- Shop: Gooseneck Hitch
- Search Results: spare tire mount
- Article: How to Measure for Trailer Hitch Drop
- Video: The Low-Down on the Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector

