Recommended Trailer Brake Controller for a 2022 Ford Edge

Question

Question:

I wanted to add a trailer brake controller to a 2022 ford edge with class 2 factory tow package . How can I do this and which controller do you recommend

asked by: Regina R

0

Expert Reply:

The best type of trailer brake controller option we have for your 2022 Ford Edge is a wireless one. The reason that this is best is because it won't require you to splice into the vehicle wiring like you would normally for a traditional trailer brake controller. In order to use this type of brake controller you'll need to start with a 4-way if you don't already have one and for this I recommend the T-One Vehicle Wiring Harness part # 118805 (All Models Except Titanium). This will then need to be converted into a 7-way using the 4 to 7-Way with 4-Way Adapter part # ETBC7L which also comes with everything else you need for a wireless trailer brake controller like the Curt Echo Wireless Mobile Trailer Brake Controller part # C51180 which is what I recommend using.

expert reply by: Conner L

0

Answer 1

While I can understand not wanting to splice any wiring, you'll have to do so to add a brake controller to your 2022 Ford Edge ST, as there isn't a plug-and-play brake controller option. So what you'll need are the following for the…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

To install a Redarc Tow Pro Liberty in your 2023 Toyota Tacoma Sport you will need the following parts: Redarc Tow-Pro Liberty Brake Controller item #RED24FR Plug-and-Play Wiring Harness for Redarc Tow-Pro Trailer Brake Controllers item #RED99FR…

view full answer...

Answer 6

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 7

Both the Roadmaster and Blue Ox tow bars are great options. But if it was my decision to make I would go with the Blue Ox Avail part #BX7420 as we have found that the Blue Ox tow bars are a little easier to connect and disconnect from. Also this tow…

view full answer...

Answer 8

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 9

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 10

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 11

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 12

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Recommended Trailer Brake Controller for a 2022 Ford Edge

Products Featured in This Question

Continue Researching