Is Replacement Entry Door Hinge for RV - 6 Leaf A Controlled Motion Friction Hinge

Question

Question:

Is this replacement hinge, part # LC198295, a “Controlled Motion” hinge i.e - a friction hinge? If yes, does the same hinge WITHOUT the friction feature exist?

asked by: Keith J

0

Expert Reply:

Nope, the Replacement Entry Door Hinge for RV - 6 Leaf - White # LC198295 is NOT a controlled motion friction hinge.

Just in the interest of being thorough, a friction hinge is available with part # LC22NJ, but it sounds like you are trying to avoid that, so go with the # LC198295.

expert reply by: Kyle S

0

Answer 1

Hey Steven! The Replacement Entry Door Hinge #LC198295 will fit your 2008 Keystone Fuzion. These are pretty much universal, and often used to replace the older 4-leaf hinges. The only thing we really can't guarantee is that the holes will line…

view full answer...

Answer 2

The Replacement Entry Door Hinge for RV #LC198295 that we offer is only 9-1/4" long x 2-1/8" wide, but you would still be able to use this hinge anyway. You'll need to drill out the rivets holding your current hinge in place then fill…

view full answer...

Answer 3

Special trailer tires should always be inflated to the maximum psi pressure figure shown right on the tire sidewall. Always check pressure and inflate as needed with the tires cold, such as first thing in the morning. As you drive and as the daytime…

view full answer...

Answer 4

Since the pin weight of your camper is 2.1k, I recommend going with the LoadLifter 5000 opposed to the 7500. While technically there is not reason you couldn't use the 7500 kit, it really is not necessary for a camper like yours. Generally the…

view full answer...

Answer 5

No the Replacement Controlled Motion Hinge for RV Entry Door - 6 Leaf - Black #LC95VR does not come with mounting hardware. You will need to reuse the existing hardware or source new hardware.

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 8

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 9

Hello Daniel, Thanks for writing in. I am sorry but, no, I would not recommend using the B&W 5th Wheel to Gooseneck Pin Box #BW73RV with a Ram truck equipped with RamBox. The challenge with RamBox trucks is that the bed walls extend farther into…

view full answer...

Answer 10

Hey Joseph, welcome back! I have two 6 Leaf friction door hinges, however they're only 9-5/8" long. They are the Replacement Hinge for RV Entry Door - 6 Leaf - White item #LC22NJ or item #LC95VR in black. These have the controlled motion…

view full answer...