Replacement Water Pump For a Shurflo 4008-101-A65

Question

Question:

Looking for a freshwater pump replacement for Shurflo 4008-101-A65. Do you carry such items?

asked by: Mark A

0

Expert Reply:

Yes, we do carry water pumps that can be used to replace your Shurflo 4008-101-A65 water pump.

After looking at the specifications of the Shurflo 4008-101-A65, I recommend replacing it with the HydroMax RV Fresh Water Pump # P25201. The HydroMax RV Fresh Water Pump # P25201 is a 12v DC pump like your Shurflo and has the same 3 gallons per minute flow rate and pressure of 55 psi.

expert reply by: Scott S

0

Answer 1

There are a number of parts needed for you to flat tow a 2015-2018 Chevy Silverado 2500, starting with compatible base plates. The correct fit will depend on if you have tow hooks or not. If your Silverado DOES have tow hooks, you need the Roadmaster…

view full answer...

Answer 2

Hey Ben! The bracket on the etrailer Scissor Stabilizer Jacks w/ Handle and Drill Adapter #e96VV is a pretty standard one and can be bolted on or welded. I'm attaching a photo of the bolt hole dimensions in relation to each other so you can…

view full answer...

Answer 3

Yes, since RV scissor jacks like the Lippert #LC285325 are all universally designed this would fit your Tristar 5000.

view full answer...

Answer 4

The HydroMax RV Fresh Water Pump #P25201 is a direct replacement for a 3-gallon-per-minute (GPM), 12V pump which is what you need. Based on my research, it looks like your existing Shurflo 2088-403-144 pump features these same specs so it should work…

view full answer...

Answer 5

The HydroMax RV Fresh Water Pump #P25201 will work great as a replacement to replace your Shur Flo part 2088 403 144. This has the same specs at 3 gallons per minute so it is a perfect replacement that will be more reliable than the Shur Flo.

view full answer...

Answer 6

In order to activate the 12V circuit on your truck's 7-Way so that you can maintain the charge on the trailer's auxiliary battery, you just need to run a length of 10 gauge wiring like #10-1-1 (sold by the foot) through a breaker like #9510…

view full answer...

Answer 7

What you need is a light kit specifically for flat-towing. The Plug-N-Tow TM Vehicle Wiring Harness, #42615, would be if the Jeep were towing a trailer and not for activating its lights while it is being towed. There are a few options for lighting…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

Both the Roadmaster and Blue Ox tow bars are great options. But if it was my decision to make I would go with the Blue Ox Avail part #BX7420 as we have found that the Blue Ox tow bars are a little easier to connect and disconnect from. Also this tow…

view full answer...

Answer 12

Hey Jonathon thank you so much for all of that additional information! To haul your bikes behind your class C Sprinter motorhome, while flat towing your Mini, I recommend the Hollywood Racks RV Rider Bike Rack item #HLY64FR and the Roadmaster Dual…

view full answer...

Replacement Water Pump For a Shurflo 4008-101-A65

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching