Can Middle Rod in Scissor Jack be Replaced

Question

Question:

need a screw bolt for my scissors jack 5/8 x 17

asked by: Russell J

0

Expert Reply:

The middle bolt that extends/retracts scissor jacks is unfortunately non-replaceable so you'll have to replace the jack(s) entirely. This is because if that bolt needs replacing then more times than not the whole jack is messed up and it's safer to replace the whole thing.

Here are our etrailer-branded jacks in different quantities:
Single - # TJSC-24
Pair - # TJSCHD-24
Set of 4 - # TJSCHD-24-4

These jacks are rated for 5,000 lbs and have a 18-3/4" lift. I've attached a review video for you to check out.

expert reply by: Jon G

0

Answer 1

Since the slot dimensions and capacity of different brands of E-Track are identical, really the only differences are the finish and the lengths the tracks are sold in. If you're using the E-Track in an area where aesthetics are important, you can…

view full answer...

Answer 2

We do carry the 33" Ark Stabilizer Jack that you are looking for with part #ARK77FR. I was able to track down a few drawings that you should find helpful. These are for the 30" #ARK94FR and the 24" #ARK34FR Stabilizer jacks. I'm…

view full answer...

Answer 3

Both of the ARK stabilizer jacks #ARK94FR and #ARK87FR can rotate 90 degrees forward and back so in a way it is 180 degrees like you asked about. The difference is the #ARK94FR has a square tube and #ARK87FR has a round tube. These are both going be…

view full answer...

Answer 4

The Ark XO Drop Down Corner RV Stabilizer Jacks #ARK87FR can be used for leveling. Ark actually has a "How to Level a Caravan or Camper Trailer" section in their installation guide. The legs have a support capacity of 1,925 lbs per jack in…

view full answer...

Answer 5

Hey Ray, yes you need to unscrew the aerator of your faucet and then clean it off as it's clogged and making the water go everywhere. Did you recently have any plumbing work done? I had this happen after that and I had to clean it several times…

view full answer...

Answer 6

Hi Peter! The Soft Start Kit for Coleman-Mach RV Air Conditioners #CM56RR is what you need. This is designed to fit Coleman-Mach Series 45000, 47000, and 48000 AC units. The 48204-669 you have falls under the 48000 so they are compatible. Where are…

view full answer...

Answer 7

Hello Joseph, Thanks so much for being a loyal neighbor since 2015. We truly appreciate you! I’m glad you finally had a chance to write in to us. I think there may have been a small typo. You listed 24" for both the open and closed measurements.…

view full answer...

Answer 8

Hey David, thanks for the picture! I went down to the warehouse and measured the mounting bolt pattern on the etrailer Scissor Stabilizer Jack item #e36VV and their identical to the ones in your diagram. This jack is going to be a perfect replacement…

view full answer...

Answer 9

Thanks for the picture of your damaged scissor jack. Based on that the part #JSC-24-IND would be an exact replacement that you could attach to the same mounting plate you have currently.

view full answer...

Answer 10

The Snoblock Snow and Ice Windshield and Wiper Blade Cover part #288-06603 is not designed to be used on a moving vehicle. If used in this fashion then the chances of it tearing would be increased therefore I cannot recommend this. However, we do…

view full answer...

Answer 11

Hey Rick, there's not a huge difference between the #TJSCHD-24 and the #e56VV that you referenced. Basically it's the mounting bracket bolt hole dimensions being a little different designed. The lift and capacity is the same aside from that…

view full answer...

Can Middle Rod in Scissor Jack be Replaced

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching