Weight Of Malone 2" Dual Purpose Hitch Receiver # MPG544

Question

Question:

What is the wt?

asked by: Marvin S

0

Expert Reply:

The Malone 2" Dual Purpose Hitch Receiver # MPG544 weighs 20lbs. Using this adapter will reduce the tongue weight capacity of your receiver by 50-percent. At most you will be able to support up to 400lbs of tongue weight and tow a trailer up to 4,000lbs with this dual hitch receiver.

expert reply by: Bud M

0

Answer 1

The psi of your trailer tires will be listed on the side wall. It will list the max psi which is what you will want to fill them to regardless of how much weight you have. For reference, the 4.80 x 12 tires we carry have a 60 psi max for load range B…

view full answer...

Answer 2

Though this technically will work when looking at all the measurements, I cannot recommend doing so. Here's my reasoning behind saying that. With your fully loaded trailer having a tongue weight of 315 pounds and your loaded bike rack weighing 50…

view full answer...

Answer 3

Your 2017 Kia Sorento has a towing capacity of 2,000 to 5,000 lbs depending on what motor and transmission you have. I recommend checking your owner's manual to make sure you are within the manufacturer's specifications. For a trailer hitch,…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 8

The main difference between the Curt Trailer Hitch Receiver part #C13416 and the EcoHitch Hidden Trailer Hitch Receiver part #EH97FR is that the EcoHitch has a completely hidden cross tube whereas the Curt cross tube will be visible from the rear of…

view full answer...

Answer 9

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 10

Hi David! There are quite a few hitches offered for your 2026 Honda Odyssey, so I definitely understand wanting to know the differences. There are basically three styles available for you and I have them broken out below: Exposed Crosstube: etrailer…

view full answer...

Answer 11

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 12

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Weight Of Malone 2" Dual Purpose Hitch Receiver # MPG544

Product Page this Question was Asked From

Continue Researching