Thule Track Nut that Will Fit Channels of RetraxPro Tonneau

Question

Question:

Hi, I just purchased a Tonneau RetraxPro XR truck bed cover and need to order the correct nuts to install a Thule TK2 onto that built in track. You have two nuts listed for the TKs. Which one would be better fit for the RetraxPro XR?

asked by: Prasith B

0

Expert Reply:

The easiest to fit track nuts for the channels of your RetraxPro XR will be the track nuts part # 853-2106 due to the angle of the "square" so that would be what I would go with.

expert reply by: Jameson C

0

Answer 1

Both track nuts you mentioned of #853-5147 and #853-2106 have M6 thread size.

view full answer...

Answer 2

The Yakima Replacement Anchor Plate Style-A, Part #Y8810074, comes as a set of 8 plates that measure 3/4-inch x 7/8-inch. The centered threaded hole measures 0.2 inches (or 5.1 millimeters) in diameter. Please refer to the photo provided. The Yakima…

view full answer...

Answer 3

The Replacement Track Nut for Thule #853-2106 uses a M6 x 17mm bolt like the Replacement M6 x 17 mm Bolt #924-0617-15. I have also included a diagram that has additional measurements outlined. The Replacement Track Nut for Thule #853-2106 is a…

view full answer...

Answer 4

Hello Sam, thanks for reaching out. The Replacement Track Nut #853-2106 is designed to work with the Thule Tracker rails, as well as most OEM roof rails. I am not sure exactly what Thule rails you have but I can provide dimension of the track nut for…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 10

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 11

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 12

Hey Melanie. The reason you can't find a replacement for your GE ARC15AACBL2 15,000 btu air conditioner is because they phased them out. In 2025 all RV AC systems had to change over to a new coolant called R32. This was a EPA mandated decision.…

view full answer...

Thule Track Nut that Will Fit Channels of RetraxPro Tonneau

Product Page this Question was Asked From

Continue Researching