What Size Hitch Opening Does Roadmaster High Low Adapter for Tow Bars # RM-058-4 Provide

Question

Question:

I need a drop hitch that fits a 2.5inch receiver on my truck, drops 2 or 4, and presents a 2inch receiver to my bike rack. I cant tell from the description whether this is 2.5inch on both ends.

asked by: Nat B

0

Expert Reply:

The Roadmaster High Low Adapter for Tow Bars # RM-058-4 that you referenced is what you are looking for as it fits into a 2-1/2 inch hitch, provides a 2 inch hitch for your bike rack, and can drop 4 inches.

expert reply by: Jameson C

0

Answer 1

Hey Paul, I checked with Roadmaster and there are indeed base plates for the 2024 Ford Escape Hybrids. Depending on what you have, here are the fits: - 2024 Ford Escape Plug-In Hybrid & Hybrid Platinum: Roadmaster Direct-Connect Base Plate Kit…

view full answer...

Answer 2

Hi Randy, Starting with the necessary parts I have the following recommendations: Baseplate: If you have a non plug-in hybrid then you'll need the #BLU92CR; if you have a plug-in hybrid then you'll need part #BLU82CR instead. Tow Bar:…

view full answer...

Answer 3

A quandary indeed, but yes you can use the Roadmaster High Low Adapter for Tow Bars #RM-058-4 with a bike rack. The main reason that we don't suggest using an adapter is because it will cut your hitch's capacity in half, and typically there…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

Both the Roadmaster and Blue Ox tow bars are great options. But if it was my decision to make I would go with the Blue Ox Avail part #BX7420 as we have found that the Blue Ox tow bars are a little easier to connect and disconnect from. Also this tow…

view full answer...

Answer 8

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 9

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 10

Since wire color codes are NOT universal, we always recommend wiring by function, rather than wire color. If you look at the Trailer Wiring FAQ article I have linked you to, you can see some diagrams showing the proper way to wire a vehicle and…

view full answer...

Answer 11

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 12

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

What Size Hitch Opening Does Roadmaster High Low Adapter for Tow Bars # RM-058-4 Provide

Product Page this Question was Asked From

Continue Researching