Is There An RV Toilet With An Elongated Bowl And 17"-18" Height

Question

Question:

I am looking for an rv toilet with an elongated bowl with ada height 17-18” can you help. Thanks

asked by: Jim S

0

Expert Reply:

The closest option we currently have that has an elongated bowl would be the Dometic 320 Full-Timer RV Toilet - Standard Height - Elongated Bowl - White Ceramic # DOM87FR or # DOM27FR for Tan. These toilets have a seat height of approximately 18-3/4".

The only other option would be the low-profile Dometic 321 Full-Timer RV Toilet - Tan Ceramic # DOM99FR, which has a seat height of 15-1/2".

expert reply by: Kevin C

0

Answer 1

Hey Richard. The MORryde GooseTech 5th Wheel to Gooseneck Pin Box like item #MR27MV has not been approved for use by Grand Design. It does not fall under their 5-year limited towable frame warranty that applies to the 2020 and newer 5th wheel…

view full answer...

Answer 2

Hey Albert, for what you are looking for yes the Furrion Chill Cube Ducted kit part #FR99TD would be your best option. You'll be blown away (pun intended) which how much better this works than what you have now and you'll also notice it's…

view full answer...

Answer 3

Hello Steven, You will want to use a 3 1/2" bit as you need a 3 1/2" hole for the B&W Turnoverball Underbed Gooseneck Trailer Hitch w/ Custom Installation Kit - 30,000 lbs #BWGNRK1320. I attached an image where it goes over the size…

view full answer...

Answer 4

You will want to remove the rubber mat when you are towing. In the instructions for the Companion Hitch, B&W states that if the truck bed has a removable bed liner or mat, it should be removed or cut to allow the base of the hitch to have direct…

view full answer...

Answer 5

Hey James, the B&W #BWGNRK1308 is definitely the correct kit for your 2013 Dodge Ram. The 45 1/2" measurement is only for short bed trucks (8' or less), so if you have the long bed then you'd actually need to measure 47 1/2" -…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 8

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 9

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 10

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 11

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 12

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Is There An RV Toilet With An Elongated Bowl And 17"-18" Height

Featured Help Information

Miscellaneous Media

Continue Researching