Spacer For Suspension Enhancement For Lifted 2015 Toyota 4Runner

Question

Question:

hello, I have a 2015 Toyota 4Runner with a 1.75 lift in the rear, 3 in the front so its level now. I will be hauling a 12 ft aluminum trailer with 2 motorcycles with a total weight of around 3500 lbs. I see the kits you have don't offer what I need with the added height I have. Is there a spacer that can be added to get me the correct setup and would you go blue or black?

asked by: Chris W

1

Helpful Expert Reply:

There is an option to add spacers to suspension enhancement for your lifted 2015 Toyota 4Runner, but not with SumoSprings. What you'll need to get are Timbrens, which replace your bump stops to offer the same type of added support as you're towing. So the correct fit for your '15 4Runner, as well as the available spacer options, are as follows:

- Timbren Rear Suspension Enhancement System # TTORSEQ

- Timbren 1" Spacer For Raised Frame Vehicles # TA25723-90AD00

- Timbren 1/2" Spacer For Raised Frame Vehicles # TA25722-90F00

expert reply by: Kyle S

1

Answer 1

As your 2021 Toyota 4Runner is lifted, you will indeed need to use spacers when installing a Timbren suspension enhancement system. The correct spacers will depend on if you will be using both rear and front jounces, and I have all options for your…

view full answer...

Answer 2

You're going to want to go with the set of Timbrens item #TABSTOR4R you were looking at. The only SumoSprings available for the 4WD 2002 Toyota 4Runner are for the front end item #SS84PV. The Timbren Active Off-Road Bumpstops item #TABSTOR4R have…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

Hey Doug! The Firestone Ride-Rite Air Helper Springs #F35FV are the right kit for your 2026 Ford F-350 FX4 dually. However, you will need to measure to be sure it fits. The distance from the top of your rear axle to the top of the jounce bump stop…

view full answer...

Answer 6

Since the pin weight of your camper is 2.1k, I recommend going with the LoadLifter 5000 opposed to the 7500. While technically there is not reason you couldn't use the 7500 kit, it really is not necessary for a camper like yours. Generally the…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 9

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 10

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 11

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 12

Hey Charles, you guys need the Malone DownLoader Kayak Roof Rack with Lift Assist and Tie Downs, part #MPG114MD-351XL, along with 2 sets of Malone DownLoader, part #MPG114MD, rather than trying to use two Hullavators. Using two Thule Hullavators…

view full answer...

Spacer For Suspension Enhancement For Lifted 2015 Toyota 4Runner

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching