Can 6K Surge Brake Actuator Be Used with 7K GVWR Trailer

Question

Question:

Is the brake actuator sixed to meet or exceed the gross trailer weight. ie, if my trailer is rated for GTW of 7000 pounds i would need an actuator with a rating of at least 7000# gross trailer weight?

asked by: Ricky C

0

Expert Reply:

The surge brake actuator will need to at the very minimum meet the gross vehicle weight rating (GVWR) of the trailer but ideally it should exceed this. The Dexter DX7.5 Drop-N-Go Brake Actuator part # 099-175-20 has a 7,500 lb weight capacity so anything rated under this will work great.

expert reply by: Conner L

0

Answer 1

For a disc brake model with an electric reverse lockout solenoid you can use #099-175-20.

view full answer...

Answer 2

There is a replacement that I recommend for the Tie Down 70E disc brake actuator, though you will want to verify that your mounting bolt holes are 3 inches apart on center and your tongue is a 3 inch channel. If they are I recommend the Dexter DX7.5…

view full answer...

Answer 3

For a Four Winns Boat Trailer with Titan Aero 6000 Surge Brake Actuator, I recommend replacement using the Titan Zinc-Plated, Leverlock Brake Actuator part #099-175-20 which is ready to go as is and will be a great fit. The reason I recommend…

view full answer...

Answer 4

Hi Ron! To get the 12v power port on your 7-Way working, you will want 12 gauge wire and a 40 amp circuit breaker (I have both listed below). This will get you needed power and protection for your Curt Echo Wireless Brake Controller #C51180. 12 Gauge…

view full answer...

Answer 5

For a disc brake model with an electric reverse lockout solenoid you can use #099-175-20. This would be a great replacement solution.

view full answer...

Answer 6

Hey Jim, the Kodiak Disc Brake Caliper #KDBC225DAC is designed so that it can be used on either side of a trailer axle so there isn't a specific left and right. This also can be used to replace a Reliable CR1000 and CL1000 so it will work for you…

view full answer...

Answer 7

The Dexter Brake Actuator part #099-175-20 replaced the Titan 60 that has a master cylinder with a fitting at the end. The fitting is a 3/16 inverted flare where the brake lines connect to. You do not need an extra fitting when you use the actuator.…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 11

Since wire color codes are NOT universal, we always recommend wiring by function, rather than wire color. If you look at the Trailer Wiring FAQ article I have linked you to, you can see some diagrams showing the proper way to wire a vehicle and…

view full answer...

Can 6K Surge Brake Actuator Be Used with 7K GVWR Trailer

Product Page this Question was Asked From

Continue Researching